Donatello
Forum Replies Created
-
ATA 100 is a older card .. go to promise site to make sure you have the newest driver for the pci card …
i have had ATA 100/133 cards go down … you might switch the cable (chan 1) to the drives that are not showing up to see if they show up on the working channel (chan 2) … -
is this ONE 1394 drive or all?
i have one 1394/USB drive that drops after about 30 min when i use the 1394 connection .. however when i connect thru USB no problem .. i have 3 other cases by same manufacturer with no 1394 problems .. i called case manufacturer and they are replacing it …
-
render as QT .. then under template choose 512K-1k for broadband .. 80-100K for dial up …
-
don’t know about software that does it on capture but ADS pyro makes a hardware unit that will convert DV data to mpeg2 on capture.
-
for future :
you might SAVE the vidcap file on all Vegas captured projects – then if V re-capture media doesn’t work you can use the vidcap file to recapture clips … -
a few times over past years i’ve had 1394 drives disconnect .. i thought rebooting help but in the end the cause was the 1394 cable .. … the old 1394 cables worked 80% of the time BUT the 20% will drive you up a wall ..
-
i think this is also referred to as SLIPping .. the current clip in TL remains the same length but you want to change the frame it starts/ends on so you slip the shot to start a few/many frames later/earlier …
-
ALSO you can get your marker/regions into a new project by copy/paste in edit details using the OLD veg that you used for rendering …
IE: the old veg – say the edit starts at 20 sec and ends at 29 min and has many regions/markers .. you render out the new clip .. you then can either copy the veg and say rename to new veg 1- delete all the media and then drop the new rendered clip into TL starting at 20 sec = now all the markers /regions will line up to the clip …
now if you want to drop another new clip from a old veg at the end of new veg 1 – you then make a copy of the 2nd old veg- then insert TIME so the edit starts at 30min and lets just say ends ends at 45min .. you then go into edit details MARKERS and copy all the markers -then go to new veg 1 and paste into edit details markers = all the markers will go into TL starting at 30min .. next copy/paste regions … now drop the new rendered clip into new veg 1 TL … now you can close the 1 min gap between 29 & 30 min ( ripple edit so all region/markers slide)
you can keep adding to TL . just remember to keep inserting time into the old veg to get the markers/regions to start where the current vegs ends – in example above it now ends at 45min so i would insert 46min of TIME at head of next old veg – copy/paste region/markers then come back and close that 1 min gap …
-
-
IMO = in my opinion
using Vegas explorer . left click on a captured clip (highlight it) below it will tell info about it IE: 720x480x24, 29.97 ,interlace ( or progressive) etc..
https://www.digvid.info/digitalvideo/glossary.php#Interlace_Scanning