Replies – Forums – Hilary Tsai

Forum Replies Created

Page 1 of 8

1 2 … 8 →

Hilary Tsai
June 24, 2024 at 8:04 am in reply to: How do I uncrumple paper?

Hi Kouraib, thank you for your answer! I tried to reply yesterday but creative cow keeps deleting it or something.

I tried caching and reversing the animation, but what happens is that the crumpled up ball stays the same throughout the whole animation instead of unfolding. I will keep looking for solutions, but I appreciate your suggestion!
Hilary Tsai
May 17, 2023 at 9:38 pm in reply to: Bump does not bake out in single file psd

Thank you! Checked all of the above, could be the bump was not at a level that could be discernible.. I will bump it up.
Hilary Tsai
February 13, 2023 at 2:38 am in reply to: What is the best way to ensure that voronoi fragments get smaller and fade out?

Amazing! Thank you so much for these solutions – I will certainly try them both out!
Hilary Tsai
February 1, 2023 at 12:54 am in reply to: How to make sure voronoi collision does not fracture the entire object?

Hi again, Michael

I just tried to follow a tutorial on weight brush and using the fixed connector, but I’ve been unable to replicate what you’ve done here. Would you be able to share with me how you achieved this?

Thank you so much!
Hilary Tsai
January 31, 2023 at 11:20 pm in reply to: How to make sure voronoi collision does not fracture the entire object?

Yes indeed it is! Thank you, Michael!! Can you tell me what settings you used to achieve this effect? Many thanks!

On looking further, it looks like you used a brush effect to select points–which I vaguely remember hearing about somewhere. I will try to look it up now. Thank you again!
Hilary Tsai
January 31, 2023 at 8:48 am in reply to: Why won’t voronoi fracture with rigid body dynamics bake into FBX?

I realized I had PLA checked on when baking the object, which was not right in this case. Now I’ve unchecked it and it did bake out
Hilary Tsai
October 11, 2022 at 9:17 pm in reply to: Transfer Plugins to New Computer

Sorry, it’s Monterrey 12.6 on my new mac, and the other one I don’t remember off-hand but it’s several versions lower (also mac). With red giant being taken over by Maxon, I don’t think it’s as easy as using the activation code, either. I’m just kinda lost.
Hilary Tsai
April 30, 2022 at 9:23 pm in reply to: Is there any way to triangulate a bucky?

Thank you so much! I’ll try this and get back to you.
Hilary Tsai
October 2, 2021 at 6:42 pm in reply to: Orange Outline still not visible despite turning off Isoline Editing

Thank you, Jim! And you are always so kind and helpful. You’ve solved my issue many a time on this forum, including this one. It’s much appreciated:)
Hilary Tsai
September 28, 2021 at 9:15 pm in reply to: Orange Outline still not visible despite turning off Isoline Editing

Hi, Jim

That was my mistake. I see now that you said Model mode, but the tutorial I was following showed he was in polygon mode and had the outline. However, the true issue is that I was a dummy and thought he had an outline when in reality, he just had all his geometry highlighted and showing up orange. This was not a true outline at all, it was an error on my part that I later realized. Thank you so much for your help! I’ve noted everything you’ve said for the future and I know it will come in handy when troubleshooting.

Page 1 of 8

1 2 … 8 →