Replies – Forums – Kristian Lam – Page 90

Forum Replies Created

Page 90 of 143

← 1 … 89 90 91 … 143 →

Kristian Lam
December 1, 2006 at 5:58 am in reply to: Intenisty Frame grabs (hdv, jpeg, uncompressed comparison)

Hi Scott,

Email me off the list and I’ll see what I can do.

support[at]blackmagic-design.com

regards

Kristian Lam
Blackmagic Design
Kristian Lam
December 1, 2006 at 5:57 am in reply to: 4 channel audio

Hi Steve,

What about the audio meters in Final Cut Pro’s Audio Mixer? Are all four channels present?

regards

Kristian Lam
Blackmagic Design
Kristian Lam
December 1, 2006 at 5:55 am in reply to: VANC

Hi,

We take the require lines and write it into the first 3 lines of the captured pixel and write them back out to VANC on output. Support for this is built in by us and not Premiere as our drivers have to reinterpret the data in the picture lines.

regards

Kristian Lam
Blackmagic Design
Kristian Lam
November 29, 2006 at 2:41 am in reply to: Can’t get DAT audio

is the audio 48khz?

regards

Kristian Lam
Blackmagic Design
Kristian Lam
November 28, 2006 at 3:14 am in reply to: hd extreme and usb port

Hi,

That port is used to void your warranty. 🙂

Seriously, it’s actually used by our engineers for diagnostic purposes (or so I’m told) and you’ll not be able to use it for anything else.

regards

Kristian Lam
Blackmagic Design
Kristian Lam
November 24, 2006 at 1:14 am in reply to: The new Intensity HDMI Card an Sony PS3

Hi,

1080p60 over HDMI is not supported at the moment. Compatibility with the PS3 has not been tested as yet. I’m having a hard time convincing Grant to get us one 🙂

regards

Kristian Lam
Blackmagic Design
Kristian Lam
November 24, 2006 at 1:13 am in reply to: De-embedding SDI audio?

Hi Jimmy,

The DeckLink Pro already outputs 8 channels (4 stereo pairs) of SPDIF audio via the 4 RCA connectors. The audio is de-embedded from the SDI stream.

regards

Kristian Lam
Blackmagic Design
Kristian Lam
November 24, 2006 at 12:55 am in reply to: Cupture problem

Hi,

DeckLink Extreme is an SD only card and will not be able to capture HD video from your camera. You’ll need a HD capable card like the DeckLink HD Extreme.

regards

Kristian Lam
Blackmagic Design
Kristian Lam
November 21, 2006 at 4:23 am in reply to: Output

Hi Charlie,

Try reinstalling the drivers again. Remember to uninstall first.

regards

Kristian Lam
Blackmagic Design
Kristian Lam
November 21, 2006 at 3:33 am in reply to: Decklink monitor output cut-off…

[jimmybee500] “Now I’ve switched off my underscan, and so assumed I’d see ALL the pixels/info I’m seeing on the PC screen? Or have I got this wrong?”

Should be the other way around. If you switch off underscan on your broadcast monitor, some of the edges will not be displayed.

regards

Kristian Lam
Blackmagic Design

Page 90 of 143

← 1 … 89 90 91 … 143 →