Replies – Forums – Darren Kunkel

Forum Replies Created

Darren Kunkel
October 31, 2009 at 11:07 pm in reply to: Engraving Help Please

Hi Adam-
As always, thanks for the quick response. BTW, I of course meant that I was using CIRCLE spline for sweeping…not a TEXT spline. Sorry about that.

If OK by you, I’ll render out the pipe utilizing the bump map and attach to this thread. Thanks again
Darren Kunkel
October 13, 2009 at 3:54 am in reply to: Transparency Distortion

Hi Adam-
THANK YOU very much for the quick response. A setting of Best helped significantly…again, much appreciated!!

-Darren
Darren Kunkel
October 4, 2009 at 6:43 pm in reply to: Convert Triangles to Poly’s

Hi Adam-
Thanks very much for the response. You were absolutely right on playing with the Angle…tried various permutations on Creating N-Gon Checkbox and various angle values….things are better.

Thanks Again….wanted to make sure that there wasn’t a silver bullet I was missing.

-D
Darren Kunkel
September 15, 2009 at 8:21 pm in reply to: Approach for Engine Cover

Hi Adam-
Thank you for the quick response!!

Totally agree….been scouring HIGH and LOW for schematics on this thing in order to obtain the “missing” views…i.e. side, top, etc.

The Porsche Service Manual is $40.00 and I’m too cheap to buy it 🙂
I’ll keep surfing to find the other views.

-Darren
Darren Kunkel
September 13, 2009 at 12:40 am in reply to: Modeling an Engine (Motor)

…make that Will 🙂
Darren Kunkel
September 13, 2009 at 12:39 am in reply to: Modeling an Engine (Motor)

Thanks for the response Brian-

-D
Darren Kunkel
September 13, 2009 at 12:38 am in reply to: Display Tag and HAIR??

Thanks Brian….sorry for the late reply.
I’ll give that a whirl…just didn’t understand why it wouldn’t work.

-D
Darren Kunkel
September 2, 2009 at 11:22 pm in reply to: NET RENDER Problem – Help

Hey Randy-
thanks so much for fielding such a goofed-up question.
That worked……

Again, thank you for the quick response!

-D
Darren Kunkel
September 1, 2009 at 6:58 pm in reply to: Animating Sweep Nurbs after Making Editable

Thanks for the quick response…..was out for a couple of days and missed this.
This works pretty well for me….working out a few kinks…such as now I see that the path/”road” I’ve created in a sweep nurb (adding a rectangle for the sweep) has a sharp edge on the sharp curves of the road. I’m playing with the Intermediate settings to smooth it out…but still having some sharp edges on the inside of my “S” curve. Not sure what’s going on there.

-Darren