Willie Toth
Forum Replies Created
-
You have to EXPORT AUDIO out of Pre pro you can’t just copy and paste it … Once you fix what you want to fix you need to save the changes and then replace the old audio with the corrected clip … The new clip will sync up as long as you keep the same start point as the original clip ………… WILLIE
-
Steven,
If you went into saturation, there isn’t any hope, in fact you may never be able to pull audable audio out of the clip, sorry I wish I had better news for you … I can take listen for you if you E-mail me a minute or so of the audio … E-mail to loganonestudio@aol.com
WILLIE
-
Adam,
Glad I could help …….. Willie
-
When you import the Video file into Audition you can see the picture playing in a monitor within the program … When you export it will remix the original with the voice over … If you record your audio and import it to P Pro you can only sync to one frame so if it is critical to be spot on then record it as I suggested in my last post … As far as equipment goes, if you have a mic input on your equipment you can record driectly on to Audition … Once the audio is remixed into the video clip you don’t have any sync issues unless you didn’t sync it up right before the remix … Make sure your session is set to a 48K sample rate … If you need more help go to the creative cow Audition 1.5 forum where I will get your post quicker than here ……. WILLIE
incidental poet
-
Jeffery,
Sorry, once it’s there it’s almost impossible to remove …. WILLIE
-
Adam,
I have done a bit of recordeing with distortion and I just went from the effects pedal to my mixer but you can’t get the dynamics that you get from a speaker … The best way is to mic the amp … I like to put the amp in a closet …….. WILLIE
-
I would highly suggest using Adobe Audition 1.5 … You can import the video clip into Audition, do your voice over and export it and Audition will mix the voice over into the clip … Personally I like to do the voice over and add it as a second audio track in Pre Pro just in case I need to make changes to it … You can plug a mic into your soundcard if you don’t have a mixer … You can purchase an adpter from Radio Shack to convert from the 1/4 phone jack from the mic to the mini phone that is needed to plug into the computer sound card … WILLIE
incidental poet
-
Thanks, this helps a lot …….. WILLIE
incidental poet
-
Bill,
Thanks for the info ……….. WILLIE
incidental poet
-
Humphrey,
Bring them into the session side, it should be a mono wave … Go to EDIT > MIXDOWN TO FILE > ALL AUDIO CLIPS if you only have one clip up … If you have more then select the one you want to mixdown … It will mixdown to the edit side and be two tracks … To improve the stereo field go to EFFECTS > AMPLITUDE > CHANNEL MIXER > WIDE STEREO FIELD … After you do that just save the new mixdown ………. WILLIE