Justin Thomson
3
COW Coins
Forum Replies Created
-
Thanks Jim,
Looks like everyone is confirming my doubt about doing a “simulation”. Perhaps that is a limitation of c4d, good thing all I need is a proof of concept. Thanks for looking into it for me.
When you get to the top, don’t forget to send the elevator down for the next guy
-
I don’t have that option either.
When you get to the top, don’t forget to send the elevator down for the next guy
-
Sorry I cannot replicate the issue, the bevel deformer on an editable cylinder work fine for me.
When you get to the top, don’t forget to send the elevator down for the next guy
-
Yea, looks like it could be.
When you get to the top, don’t forget to send the elevator down for the next guy
-
That is a lot of polys, are you sure they are all necessary? Will there be close up render>?
When you get to the top, don’t forget to send the elevator down for the next guy
-
I don’t quite understand, can you post an image
When you get to the top, don’t forget to send the elevator down for the next guy
-
Will need to see the file. might have something to do with the Sub Surface.
When you get to the top, don’t forget to send the elevator down for the next guy
-
Well, if it’s only one piece that stick at the end of the animation you could just key frame that one.
When you get to the top, don’t forget to send the elevator down for the next guy
-
I would have to see the AI file.
When you get to the top, don’t forget to send the elevator down for the next guy
-
looks like it’s a multipass of the depth channel.
When you get to the top, don’t forget to send the elevator down for the next guy
