Eric Toline
Forum Replies Created
-
Two different animals. The 788t is a recorder, the Nomad as you know is a mixer/recorder and a lot more flexible with way more bells & whistles than a 788t. I think your choice is clear.
“I push the RECORD button and hope for the best”
-
Sure it can. Go from the RX 3.5mm output connector to whatever is the audio input on your phone with the appropriate connecting cable, adjust the levels, push the record button icon thingy on phone and hope for the best.
“I push the RECORD button and hope for the best”
-
If there’s nothing in the user manual about the blinking then I would call Sennheiser tech support in Connecticut. The number is 1-877-736-6434 ext 3
Eric
“I push the RECORD button and hope for the best”
-
For workout videos regardless of the brand be sure to get the dual ear mounting system. The normal single ear mounting has a tendency to move around during workouts if there’s a lot of head movement and can fly off the user unless tape is used to hold it in place.
“I push the RECORD button and hope for the best”
-
Unscrew the rubber boot at the back of the XLR connector and push the connector block & the cable clamp out towards the back from the front of the connector.
“I push the RECORD button and hope for the best”
-
If you ordered the original Sennheiser cable it’s not a matter of if it will fail but when. Every Sennheiser output cable I have made was as a replacement for the original Sennheiser cable. Their cable is not repairable as the connectors are molded onto the cable itself. Wondering what the new cable cost was?
Eric
“I push the RECORD button and hope for the best”
-
The output connection on a G3 receiver is unbalanced & the mic level XLR input on the DR40 is balanced. Wired correctly the cable will have the positive going from the tip of the 3.5mm TRS connector & to pin 2 of the XLR. The cable shield/ground will go from the ground connection on the 3.5mm connector to pins 1 & 3 of the XLR. Open your XLR and check to make sure it’s wired as I described. I’ve made hundreds of G2/3 output cables wired exactly like that and everyone works perfectly for the job.
Eric
“I push the RECORD button and hope for the best”
-
Adjust the levels to match in post. If it’s always the same low talker than speak to him about speaking up.
Eric
“I push the RECORD button and hope for the best”
-
Most often the client will request a boom & lav split track and then screw it up in post by mixing both together.
Eric
“I push the RECORD button and hope for the best”
-
Anything you do with compression & peak limiting on the non VO parts is going to help. Try it, you have nothing to lose and everything to gain. (pardon the pun)
“I push the RECORD button and hope for the best”