Replies – Forums – Edward Brosens

Forum Replies Created

Page 1 of 2

1 2 →

Edward Brosens
May 3, 2012 at 7:40 am in reply to: FCP 7.0.3 cannot render filters

So, six months ago everything was working fine?
Have you tried reinstalling MB Looks?
Edward Brosens
May 3, 2012 at 7:35 am in reply to: A video setting mismatch that I can not locate

What happens when you click ‘yes’ if FCP asks you to match the sequence settings with the footage?
Edward Brosens
April 9, 2012 at 3:28 pm in reply to: Extend edit to fill a gap without using the mouse

When selected with ‘v’ hold down ‘control’ push the ‘arrow down key’ and hold, release the ‘control key’ (still holding arrow down), press ‘e’.
Edward Brosens
March 1, 2012 at 6:02 pm in reply to: Final Cut Random Crash on Export

Obviously there’s something wrong with the footage.
However, you can render out the sequence piece by piece with a selection of a few clips at a time.
Or if you’re rendering a nested sequence then make sure nothing on the timeline is selected and render out small sections using in and out points.

Make sure to save your project each time you succeed in rendering a part of the sequence.
By the time you reach the corrupted footage you will know wich part is causing the problem.

Then you can delete or recapture that piece of footage to fix your problem.
Or just find another shot that works just as well.
Edward Brosens
February 29, 2012 at 9:28 pm in reply to: FW800 hub

You could try to prevent drives from going into sleep mode in the Energy Saver preference pane in System Preferences.
Or try this software: https://www.macupdate.com/app/mac/31158/keep-drive-spinning

Daisy-chaining the fourth drive should not be a problem.
Edward Brosens
February 29, 2012 at 9:17 pm in reply to: Final Cut Random Crash on Export

What happens if you don’t use compressor and export it right away from FCP with the current video settings? ( Command + E)

Is the sequence completely rendered out? (even the green lines)

Another option is to nest the complete sequence into another sequence. you can do this by selecting all of the clips and press option + c, press OK then save your project first and render it out.
Edward Brosens
February 29, 2012 at 9:00 pm in reply to: Freeze Frame Hue Change on export

Hey Derek,

I think I know what you mean and it might be happening due to a difference in gamma settings.

What happens if you set the video processing settings like this (sequence settings)?
Edward Brosens
February 29, 2012 at 8:42 pm in reply to: Scrolling Text (like MS DOS)

The animation of the text moving up should not last longer than one frame.
So, on the text layer just set two keyframes right next to each other and adjust the height of the text.
Edward Brosens
February 23, 2012 at 12:07 pm in reply to: Learning FCP

Check out Larry Jordan on Lynda.com.

Very good and entertaining course.
Edward Brosens
September 16, 2010 at 7:31 pm in reply to: Studio recorded sound, ‘outside’ simulation.

I have a couple of standard filters that ship with Final Cut Pro and Soundtrack Pro.

Thank you Bob, that was very helpful.

Page 1 of 2

1 2 →