Willie Toth
Forum Replies Created
-
Ruby,
First I have to say with using a lav mic you will be able to cut a lot more than if you were using a shotgun, or other mic system … What are you recording into? I use a wireless system and record into a portable Tascom digital 8 track … The noise you want to get rid of can be bothersome because of the shared frequencies with voice, but it isn’t impossible … You will need to bring the clip into the EDIT side of the program and highlight JUST THE NOISE you would like to remove … Once you do that go to EFFECTS > NOISE REDUCTION > NOISE REDUCTION > CAPTURE NOISE PROFILE … Once you capture the profile highlight the whole clip go to EFFECTS > NOISE REDUCTION > NOISE REDUCTION … Here is where you MUST take care not to remove too much of the noise at once … I like to remove it by about 62% and if I need more I reduce the percentage … When you preview and it sounds like people are talking in a rain barrel you are going too far … If you would like you can always E-mail a short clip to me and I will see if I can come up with a suitable FFT file for you to use … My E-mail is loganonestudio@aol.com … Good luck …….. WILLIE
-
Go to the multi track side and then click on the tab across the top that says INCERT, now scroll down to audio from there go to where your MP 3 is saved click on it and hit OK … It should incert … Once you do then you can do a SAVE AS and save it as an PCM wave file … IF Audition still doesn’t see it then it is most likely your download that has a problem …….. WILLIE
-
Does your install of Audition see any MP3’s? Try and download again only save as PCM wave file … Did you try and insert it on the session side? WILLIE
-
Ron,
Audition does have a filter for voice removal, however I haven’t really tried it and don’t know how effective it is … I am at work and don’t have the program in front of me and am brain farting on it’s location … Go to the effects tab and look for it in noise removal … If you can’t find it look in the help file ………. WILLIE
-
Max,
Echo is almost impossable to remove … The best thing that you can do is try and EQ and compress to try and put it into the background … If you like you could E-mail a couple minute clip to me and I can see if I can come up with a workable solution … If you chose to do so you can E-mail it to loganonestudio@aol.com … I can’t say I can help but I will certainly give it a try … WILLIE
-
Thanks, glad I was able to help …….. WILLIE
-
Ozpeter,
Well, ya learn somthin new everyday … Never needed to use this feature so I never looked for it … Thanks ……. WILLIE
-
sORRY IT SAYS fill single click, NOT REMOVE
-
Jim,
I have used this feature and believe me you are money ahead by sticking with the write program that you are used to using …
Willie
-
Bring your clip back into Audition expand it so you can see the click now go to VIEW>SPECTRAL VIEW make sure that the marquee tool “M” is selected and starting at the bottom of the click highlight it … Now go to your Click/pop eliminator and at the bottom of that page you will see REMOVE SINGLE CLICK … This will remove that click … If it is over music or voice sometimes it will degrade it, but for the most part the feature works fairly well …………… WILLIE