Willie Toth
Forum Replies Created
-
Ruby,
I hope you are successful, but if not I will be here until Thursday, I have a shoot in Montana ………. WILLIE
-
Ruby,
This has nothing to do with the wireless, but more the way the person spoke, a windscreen over the mic would have helped … The solution will take a while but I think it will take care of it … You need to go into view and switch to SPECTRAL VIEW highlight your pops one at a time and then hit REPAIR TRANSIENT located under farvorites, you have to make sure you don’t highlight too large a piece otherwise it won’t work … If it still isn’t getting the results that you are looking for E-mail me a minute or so and I will see if I can get you headed in the right direction … E-mail to loganonestudio@aol.com … I wish there was a faster way but in my experience this is the best way … WILLIE
-
-
Mark,
Give this a try … Using the PARAMETRIC EQ I would pull some mids out this will thinkin things up a bit, then I would do a hard limit … Keep the default settings with the exception of MAX AMPLITUDE, I would set that to -1db …
-
Mark,
Bring your file into the edit side highlight a small section of JUST THE BACKGROUND NOISE go the EFFECTS > NOISE REDUCTION > NOISE REDUCTION > OK now highlight the whole clip and go to the noise reduction again and preview (it will be open with the last setting used) … You will have to adjust the percentage of reduction, if you take too much out at one time it gets ugly, moocho ugly, I fondly refer to this as the “rain barrel effect” not good Grasshopper … WILLIE
-
One must be very careful when removing sounds, if you can E-mail me a minute or so I may be able to head you in the right direction … E-mail to loganonestudio@aol.com ………. WILLIE
-
Waveform View (the default) displays a waveform as a series of positive and negative peaks. The x-axis (horizontal ruler) represents time, and the y-axis (vertical ruler) measures spikes, or increased amplitude, in a waveform.”
-
Try using the Parametric EQ, do a mid cut and a low boost … If that doesn’t get you what you want write back ………… WILLIE
-
I still think you would be money ahead by using 1.5 and to be honest with you I am thinking that it may clear up some of your problems ……… WILLIE
-
I would just experiment with differnt EQ’s and effects such as reverb … If you are looking for that deep rich voice you may be able to add a low boost using the parametric eq or try pitch bender under the time/pitch filters ………… WILLIE