Ulflaursen
Forum Replies Created
-
2u2
/Ulf
Rgds.
/Ulf – Denmark -
Hi,
What is your input and output media?
Is it DV to DV or DV to Mpeg f.ex.?
I have never myself seen this in Vegas before.
/Ulf
-
I like the ‘S’ for splitting clips very much
/Ulf
Rgds.
/Ulf – Denmark -
Hi Luke,
I just did some test on my test PC, a 3.0 GHz, 1 GB RAM, 256 MB AGP card – nothing fancy today.
When I playback DV material without any effects etc. my CPU usage is 8-15%.
If you get 100% there is something wrong with your setup. Have you had this trouble always or has it just surfaced?
Have you tried to e-mail the support?
/Ulf
Rgds.
/Ulf – Denmark -
Hi,
I had some problems with vegas on 2 different PC’s a year ago. My problem was that the preview was sort of jumping once in a while, as if there was not enough power. I had 3.2 and 2.4 GHz machines with 1.5 and 2.0 GB ram, different graphicscards and diferent harddrives etc. Both PC’s had genuie Intel boards with 925 chipset. I tried to mix the hardware from the 2, still the same both in ver. 6 and 7.
Now I have upgraded both PC’s one to dualcore and one to core 2 duo, both with ASUS boards – both recommended or tested with Vegas. I have only tried the dual core until now, but it seems to be ok.
I can only conclude that my trouble was motherboard related. Back when I first had my problems, I had a lot of communication with support, and the sony forum. A lot of helhfull people came with all kinds of good ideas for a solution, but nothing worked.
I am not sure that your problems are related to mine back then, but perhaps it can give you some ideas.
Godd luck hope you get it sorted out…
Rgds.
/Ulf – Denmark -
Quote “Yes I can. Even if I turn up the software mixer output to 100% and the wave to 100% it is still very different.”
Actually this works. The way I first tested it was with windows media pl. compared to timeline playback in PPRO, and there was difference. When I raised the output leveler inside WM pl. it worked 🙂 and audition too. But still strange that I have to put the levelers all to max. Maybe it is an impedance issue. Dunno, but it works now.
Thanks for leading my attention to windows mixer again, Blast1 🙂
/Ulf
Rgds.
/Ulf – Denmark -
Thanks Blast1 and Vincent.
I have a lot to go for now – need to go shopping 🙂
/Ulf
Rgds.
/Ulf – Denmark -
Thanks Blast1
Yes I can. Even if I turn up the software mixer output to 100% and the wave to 100% it is still very different.
/Ulf
Rgds.
/Ulf – Denmark -
Will the third drive increase speed?
If I have a systemdrive, WD Raptor 10k drive, and 320 GB (raid 0 on two 160 GB disks) and a single drive as third, what should go on the raid set and what on the third drive?
/Ulf
Rgds.
/Ulf – Denmark -
Thanks Peter and Blast1. I’ll try the latest too.
/Ulf
Rgds.
/Ulf – Denmark