Replies – Forums – Todd Drezner

Forum Replies Created

Todd Drezner
November 20, 2006 at 1:09 am in reply to: Upconversion with Panasonic 1200A

I haven’t had any luck, but I’ve gotten some suggestions on the Varicam forum, which I will try when I’m back in the office tomorrow. Thanks.

Todd
Todd Drezner
November 20, 2006 at 1:07 am in reply to: Upconversion with Panasonic 1200A

I’ve left the office where the deck is, but I’ll try tomorrow and let you know. I know 600 was set to 1394. Not sure about the other. Thanks.

Todd
Todd Drezner
November 19, 2006 at 8:31 pm in reply to: Upconversion with Panasonic 1200A

John,

I’ve been trying to capture over FW. As far as I can tell, all menu settings are correct, but I continue to get an error message that there is no video. My easy setup is DVCProHD 720p24. I’ll review the menu settings again — must be something in there. Thanks very much for your help.

Todd
Todd Drezner
November 19, 2006 at 7:41 pm in reply to: Upconversion with Panasonic 1200A

Thanks. I didn’t realize I needed a capture card.

Todd
Todd Drezner
November 19, 2006 at 7:26 pm in reply to: Upconversion with Panasonic 1200A

Thanks. Is this something that can only be done with a capture card? Is it not possible with a direct firewire connection?

Todd
Todd Drezner
September 6, 2006 at 8:40 pm in reply to: Render Problem

Deleting the render files worked. Thanks for the help,

Todd
Todd Drezner
August 6, 2005 at 1:02 am in reply to: Strange Downconversion Problem

Yes, I’m capturing directly out of the deck over Firewire. I’ll try that menu setting — it’s one I didn’t try earlier. Thanks,

Todd
Todd Drezner
July 29, 2005 at 4:49 pm in reply to: Downconverting with 1200A deck

Thanks for your help.

Todd