Forum Replies Created

Page 1 of 2
  • Ron Smith

    October 28, 2019 at 8:12 pm in reply to: Black Flicker Frames in Timeline Viewer in DaVinci 16

    Hello,

    I am having that same problem.
    Were you able to solve it.
    Thank you

  • Thanks! the timeline grade won’t work because that happens after clip structure.
    Grouping the whole timeline and doing a grade PREclip might work.thanks!

  • Ron Smith

    July 10, 2015 at 1:47 pm in reply to: No CUDA acceleration Hardware Detected! LIES!!!!

    try this one.
    https://www.nvidia.com/object/macosx-cuda-6.5.18-driver.html

    I have your same setup and it works smooth on mine

    6.5.18

  • Ron Smith

    March 3, 2011 at 4:13 pm in reply to: Looping more than 1 shot

    It IS possible with the Davinci Panels , MY question, is it possible Without the panels and just using just a mac keyboard?? ALSO on that note is their any key on the mac keyboard that acts as , and : which
    grabs the the previous scene’s color and the one prior to that respectively.

    All the above is possible with Davinci panels but What about Without is the ??
    Thanks

  • Ron Smith

    December 9, 2010 at 9:54 pm in reply to: Softraid and benchmark

    My Numbers are similiar in software raid0(striped).
    Does anyone have results in Software raid1(mirrored)??
    Is it the same or less,thinking of going to raid1(mirrored) for backup protection, but curious if I will lose performance .
    Any results would be appreciated.
    thanks

  • Ron Smith

    December 8, 2010 at 5:34 pm in reply to: Tangent Wave Sensitivity

    Is anyone else having problems with sensitivity of certain bank knobs on Tangent panel? Specifically the ones that Do NOT have their own customized sensitivity. A FEW are fine but MOST like Red offset need 6 rotations to get 1 increment change..(Problematic Bank Knobs:LIFT,GAMMA,GAIN,MASTEROFFSET,REDOFFSET,PAN,TILT,BLUR RADIUS ETC…..) I used the same wave panel with Apple Color and the problematic bank knobs respond perfectly ,so it is not a hardware situation. Is their any file in Preferences(applicationsupport) I can check or replace??
    It is just strange that a few work right and others hardly at all..
    Any input would be greatly appreciated.Have emailed davinci as well.
    tangent wave firmware1.9.,Boot version 1.4 ,resolve7.03
    thanks

  • Ron Smith

    November 19, 2010 at 5:55 am in reply to: Tangent Wave Sensitivity

    The Sensitivity of the ones that can be adjusted are fine,everything else is almost USELESS.
    The knobs are not defective because they work great with Apple Color.
    Is everyone having this issue??Would it be a Tangent or Resolve issue??
    I

  • Ron Smith

    November 10, 2010 at 6:06 pm in reply to: Tangent Wave Sensitivity

    Thanks Sascha, the encoders work fine with Apple Color,almost think it is some file that is not right with resolve and Wave communication.

  • Ron Smith

    November 10, 2010 at 5:50 am in reply to: DaVinci Resolve Trim LUT DPX image where is it?

    Yes It is not on mine as well .Good ??

  • Ron Smith

    November 4, 2010 at 6:19 am in reply to: New System Optimization

    Yes I get that same thing and can not get audio from a quicktime as well.
    Thanks for bringing it up

Page 1 of 2

We use anonymous cookies to give you the best experience we can.
Our Privacy policy | GDPR Policy