[Rick Kz]

interesting update… i have narrowed it down to a corrupt sequence -but when i re-launch FCP it defaults to the last open project with the corrupted sequence on the timeline and the beach ball of doom
is there a quick key to disable “load last project”

thanks again

[Rick Kz]

with so many options available, can anyone recommend the best boot.ini 3Gb switch options to utilize the 4Gb of installed ram in this 32bit winXP cpu?
again, many thanks in advance

[Rick Kz]

thanks for the info!
there is a AJA kona LHe installed- and i do not have a frame available at this time- the frustrating part is that the deck that the final is to be recorded on is DV/HDV input, no SDI (one of the economical sony HDV decks) could i just set the field order in compressor? i believe the editor may have used one of the pre-built settings in compressor such as “reformat/DV NTSC anamorphic”, could this be modified to uncompressed field 2 dominant?

[Rick Kz]

i could not agree more… problem is that the cpu boots fine with the atto FC41ES removed- apple will claim its the card, not the cpu- to make matters worse, i have seen this problem with different cards and different cpus (you know, if you have the opportunity to mix and match to confirm a dead card or logic board)

fun stuff

[Rick Kz]

the bummer side of this solution is that the 1200A with the input set to 1394, the HD-sdi and analog component HD output flickers like crazy
panasonic notes this in the 1200A docs and, so far, has no plans to fix this
of course the real solution is a kona card