Replies – Forums – Olwiggum

Forum Replies Created

Olwiggum
April 12, 2007 at 11:52 pm in reply to: Computer not responding to GL-1

So my other little Canon stopped working with the computer as well. I have tried both cameras on 2 other computers with different cables.

So how would a faulty PCI slot damage something inside the camera?
Olwiggum
March 23, 2007 at 7:01 pm in reply to: Computer not responding to GL-1

I doubt it’s a faulty PCI slot. It’s been working fine for a couple of years and it still works with another Canon cam. Any suggestions about making it work with the GL1 again?

A friend suggested that the driver that recognizes the cam may have gone corrupt. But wouldn’t it stop recognizing the other cam as well? Also, how would I go about finding that specific driver if that is the case?
Olwiggum
July 2, 2006 at 1:26 am in reply to: Did Windows Service Pack 2 cause problems for you?

I reformatted my system drive and reinstalled XP last night. My 300 gig drive was showing only 137 gig capacity, and some googling revealed that it was an issue with not having Service Pack 1 installed yet. So I got it installed and the gig showed up as 300 gigs.
I didn’t install SP2 for fear of the same thing happening again with my capturing.
I got Premiere reinstalled today and captured a 50 minute clip with no problems. 🙂
Olwiggum
June 24, 2006 at 6:14 am in reply to: Did Windows Service Pack 2 cause problems for you?

Thanks for the response. It’s not the answer that I was looking for, but at least I know the problem now.
(I hate re-installing XP).
🙂

Thanks again.
Corey
Olwiggum
June 22, 2006 at 1:51 am in reply to: “Can’t Find Timecode During Capture”

Anyone know why the SP2 would cause such problems and how I can fix it?
Olwiggum
June 20, 2006 at 5:38 pm in reply to: “Can’t Find Timecode During Capture”

“Did you turn off all the annoying SP2 security settings, firewall, DED, etc? Also turn off the restore-monitoring for all drives except the system drive?”

I just tried un-installing and re-installing Premiere? A few weeks ago, I went through the control panel and uninstalled a bunch of stuff that looked like it was associated with the Service Pack 2 and that didn’t fix the problem either.
How do I turn off the restore-monitoring for all drives?

Why does the Service Pack create such problems? I didn’t do this for my other hard drive that is currently installed?
🙁
Olwiggum
June 20, 2006 at 12:31 am in reply to: “Can’t Find Timecode During Capture”

No. The drive is internal. I believe it was SP2. Is there a way to fix the problem?
Olwiggum
May 4, 2006 at 11:50 pm in reply to: getting a blue screen when exporting to tape

Also, it doesn’t when I capture from the cam to the PC, only when I go from the PC to the cam. Would there be a solution to that?
Olwiggum
May 4, 2006 at 11:02 pm in reply to: getting a blue screen when exporting to tape

I’ve used different cables and 2 different cameras. I guess it’s the card then, huh?
🙁