Ken Adolph
Forum Replies Created
-
thanks Steven
I hope they fix this in the next release.Ken Adolph
Media Group
Editor/Post Supervisor
https://www.mg.ca -
If you go to my website http://www.mg.ca you can find a price list in pdf format on the left side. the prices are in canadian $
i.e. 30 minute show is $400 or $320USJust to give you an idea of what to charge your clients.
Glad I could help. Good luck.Ken Adolph
Media Group
Editor/Post Supervisor
https://www.mg.ca -
I think there are some people on this list who are producing for television including myself. We have CPC closed caption software and an SDI encoder box which can do CC and Open Caption, etc.
I think that our software hardware combination cost approx. $15,000US so the investment is quit high to get started. This is why most people send their captioning to an outside supplier.
Have a look at this from their website.
https://www.cpcweb.com/Captioning/cap_decision.htmBy the way I am not affiliated with CPC at all. It is just the fact that they are one of the only companies doing this kind of software.
Ken Adolph
Media Group
Editor/Post Supervisor
https://www.mg.ca -
these guys are the gods of captioning
https://cpcweb.com/Captioning/soft_compare.htm#The%20CCaption-DV/NLE
Ken Adolph
Media Group
Editor/Post Supervisor
https://www.mg.ca -
Automatic Duck does not make an exporter for PPro. The only ways that I know of doing this is the way you have done it or save an EDL from PPro and open it and recapture in FCP.
I wish there was an exporter for PPro. But not right now.Ken Adolph
Media Group
Editor/Post Supervisor
https://www.mg.ca -
Thanks John,
I have passed this on to our editor.
I am suprised that FCP doesn’t allow for this in order to sync to footage, either Hdcam or film.Ken Adolph
Media Group
Editor/Post Supervisor
https://www.mg.ca -
If all that stuff is onboard then you have to use the driver disk that came with the motherboard.
Ken Adolph
Media Group
Editor/Post Supervisor
https://www.mg.ca -
Yes, we found this out the hard way. We were hoping to keep one of our DS boards running as a framebuffer for Combustion/Max on our graphics machine. We installed the Axio SW codecs and the machine quit. It’s to bad that matrox can’t fix this problem! We had to buy a decklink card in order to get framebuffer for Comb/Max. I would have paid Matrox for the SW codecs if they kept my DS board working.
Ken Adolph
Media Group
Editor/Post Supervisor
https://www.mg.ca -
As Aanarav said in his post “What are you looking for?” in a new version.
Ken Adolph
Media Group
Editor/Post Supervisor
https://www.mg.ca -
Thanks Mike,
Do you know whether I can upgrade to the pro version from the standard edition within PPro? there is no information about this on the sorenson site.Ken Adolph
Media Group
Editor/Post Supervisor
https://www.mg.ca