Job Ter burg
2
Avid Coins
13
COW Coins
Forum Replies Created
-
Makes little sense anymore, as perpetual licenses are going to be killed off per 2026 or so. The original posting is from 2022…
-
Those burnins aren’t coming from MC, as far as I can tell. So likely, this is how the footage was delivered to you. No way to get rid of that, other than asking for a clean re-delivery from the dailies supplier.
-
Another vote for speeding it up. In fact, I don’t know of any way to properly do 24-25 (or vice-versa) without speed change, that would be good enough to get you through QC. Although it depends a bit on the content; some 2D animated shows may not even be created at a full 24 or 25, so then doing a Both Fields slowdown or speedup wouldn’t show as clearly.
-
Drag them to Site Settings.
-
There should not be any delay other than the one caused by the client monitor itself. And yes, Desktop Play Delay settings help you adjust for that, plus the MonConDel command in the console (to bring Source/Record monitors in sync with the delayed audio). No amount of gear (neither another computer nor another BoB) is going to help bring down the delay caused by the monitor itself.
-
I worked out the cost of the various ways to get MC. Not accepting any liability or responsibility for anyone’s purchasing decisions. Just sharing a sheet that helped me figure out the differences.
Here’s the sheet: http://www.terburg.com/EVEN/MC2021pricinglongterm.pdf
-
MC has similar AutoSync features. If shot with common timecode, you can select all picture and sound clips for a given shooting day, and choose Clip->AutoSync.
If not shot with common timecode, you need to either set markers for the clapper board, or you may try and use waveform syncing.
-
LG OLED
-
What Pat says.
Also: mostly errors like these are caused by one or more corrupt effects; miscalculated audio crossfades and/or flaky AudioSuite renders. On my latest feature, I had used two different machines, each of which turned out to run a different version of a specific plugin, and this led to issues. Which I managed to track down by using the classic ‘divide and conquer’ method Pat already suggested.