Replies – Forums – George Anderson

Forum Replies Created

Page 1 of 4

1 2 … 4 →

George Anderson
March 22, 2013 at 7:59 pm in reply to: upgrading system and computer

I may have to try Premier. I’m curious anyway.
George Anderson
March 22, 2013 at 7:58 pm in reply to: upgrading system and computer

Awesome David! Thank you for the comments! I have something to think about.
George Anderson
October 5, 2012 at 7:54 am in reply to: FCP won’t recognize DV/Firewire. Can’t log and transfer.

Thanks! I tried to trash my preferences once. But that didn’t seem to do anything. I followed those exact instructions and it still would not recognize the camera or the miniDV deck.
What is DIsk Warrior?
George Anderson
September 9, 2010 at 9:12 am in reply to: Sorensen Squeeze 6 moving audio out of synch

Quicktime setting.
George Anderson
April 11, 2010 at 4:20 am in reply to: Storage device power failure

Sweet!
Thanks, for your help. I’m going to keep my fingers crossed and try again.
George Anderson
April 9, 2010 at 7:00 pm in reply to: Storage device power failure

Well, I must be doing something wrong although I’m hard pressed to understand what. It seems pretty straight forward to me. I put the drive in, booted up the computer, but I don’t see the drive. It’s a 1.5TB drive from Western Digital. Is it possible that because it’s 1.5TB that it just doesn’t fit?
George Anderson
April 8, 2010 at 8:13 pm in reply to: Storage device power failure

Thanks, Bob.
It’s a Western Digital. I never set it up to be an eSata drive. Does that matter? So, I just break open the case and pull out the drive and stick it in the Mac? Ok. I’ll try that this evening when I return. Thanks for your help.
George Anderson
July 2, 2009 at 12:33 am in reply to: Is there some type of audio offset in FCP when importing?

Ok, thanks!
George Anderson
July 2, 2009 at 12:10 am in reply to: Is there some type of audio offset in FCP when importing?

Yes, I’m using an Apogee A/D converter. This is plugged into the back of the computer and the MiniDV deck is plugged into the front. Both are operating at the same time. I tried trashing my preferences sometime back for the same issue with no change. Would there be another way to use my Apogee?
George Anderson
July 1, 2009 at 11:29 pm in reply to: Is there some type of audio offset in FCP when importing?

Okay,

I captured the footage both times from MiniDV. I used a JVC MiniDV/HDD/DVD deck to capture via Firewire. I used Easy Setup DV/DVCPRO NTSC to capture. The clip is 29.97

My sequence settings are:
Frame Size: 720×480
Pixel Aspect Ratio: NTSC
29.97
Quiktime Vid Settings:
Compressor: DV/DVCPRO – NTSC
Quality: 100%
Audio: 48kHz
Depth: 16 bit

Timeline: Drop Frame box is checked
Starting code: 00:58:30;00
Render Control
Filters and Frame BLending are checked.
Grame Rate and Resolution: 100%
Codec is same as sequence
Master Template: Best

Page 1 of 4

1 2 … 4 →