Replies – Forums – Frank Mulder

Forum Replies Created

Frank Mulder
April 27, 2013 at 2:59 pm in reply to: Qualityloss exporting into Proress422?

Thanks Ryan for the reply.
Frank Mulder
January 22, 2013 at 6:50 am in reply to: Sony EX1 Cannot proceed (Histogram)

That’s no problem Jim. You not being helpful was actually …. quite helpful 😉

In the menu (submenu display On/Off) the Histogram option was greyed out. So even there it was not possible to activate the histogram.

I did not mention that I had this problem on the EX1r (and I compared it with a different camera …. yep an EX1).

What I did not expect was that when I re-entered the config from a card, the SD/HD mode is not being reset. I assumed that everything would be back to our basic settings.

The camjo-colleague told me he had shot in HD (for his TV-monitor he was using during edit could only show SD and thus he could not use that device). But I guess he must have played around in the menu and set it to SD. He told me though that he did not alter the menu … only the output was set to SDI.

Well, now I know that he was not telling the truth, the whole truth and nothing but the truth. (may God help him, when I see him ;-))
Frank Mulder
January 22, 2013 at 6:39 am in reply to: Sony EX1 Cannot proceed (Histogram)

Thanks for replying David. Your suggestion though could not have been the cause, for I had re-entered our templateconfig from a card we use.

In the menu (submenu display On/Off) the Histogram option was greyed out. So even there it was not possible to activate the histogram.

It was Jim’s suggestion that did the trick.
Thanks anyway for replying.

Cheers.
Frank Mulder
December 5, 2011 at 3:14 pm in reply to: Compressor convert FLV to MOV

Hi Mark,

thanks for the response. I’ve tested the batchproces … now I’m goin’ to try to find a way this could be automated…..

Again, thanks for responding.
Frank Mulder
April 22, 2010 at 1:52 pm in reply to: Sony XDCAM Transfer trouble with 8 channel audio

Hi Wayne,

It’s not that I want to import 8 channels. 2 or 4 would be sufficient. This afternoon I got new material which was 8 channel, 16 bit. I assumed it would give the same error, but it did’nt. (Confused).

There is an option where I can click ‘Only import monitored audio channels’ In combination with the general setting to monitor only audio channels 1/2 & 3/4 makes the error disappear.

Thanks everybody for your reactions.
Frank Mulder
April 22, 2010 at 12:59 pm in reply to: Sony XDCAM Transfer trouble with 8 channel audio

Hi Jeremy,

sorry for not reacting …. I’ve mailed them this morning for an evaluationversion.

Thanks.
Frank Mulder
April 22, 2010 at 6:35 am in reply to: Sony XDCAM Transfer trouble with 8 channel audio

Hi Wayne,

I had V2.11 and now tested V2.12 ….. snif …. no improvement.
Frank Mulder
February 18, 2010 at 7:26 am in reply to: FCP export to MXF

Jan, Frans,

Kunnen jullie aangeven hoe jullie het hebben opgelost.