[Dan L.]

I have to agree,

It seems like it should be a quick fix to be able to modify a master clip, as well as a sequence. All a master clip is is timecode numbers at that point.

Seems like it should be a lot easier to modify a master clip, or make a duplicate master clip that is in the right project format.

Best,

Dan

[Dan L.]

Thanks Michael,

I did try the Modify Sequence, but I couldn’t get it to work, I wasn’t looking for a DUplicate sequence, so I will give it another shot.

Best,

Dan

[Dan L.]

I’ve found Mojo to be a little touchy with the dv connector. Do you have the deck connected to the firewire port of the mojo, and have you selected DNA rather than OHCI in you deck config?

Best,

Dan

[Dan L.]

You need to configure a deck in the deck configuration.

Also do you have mojo? I have mojo and I had to power it down to digitize via ohci. XpressProHD didn’t recognize the deck although windows did, until I powered down mojo, then I could config as an ohci and digitize via A regular firewire card.

Normally I would connect the deck via 4pin to 4 pin firewire cable from Mojo firewire port to the deck, but I did not have that cable Handy.

HTH,

Dan

[Dan L.]

What are you talking about rendering?

The whole point of Mojo is that you don’t need to render to output with DV25

Best,

Dan

[Dan L.]

If you wish 3d text, you can upgrade to XproHD, it comes with Marquee title tool that adds 3d functionality.

Best,

Dan