[Chris Tompkins]

Same here. I was on M100 from 96-2005. Using a Mackie Mixer then as I do now w/the FCP set up.

[Chris Tompkins]

I’ve done this very thing 3 times now. Not a problem. I leave the drives powered down until I get to the install of the controller card driver. You should be fine.

Chris

[Chris Tompkins]

I would re-format if you can w/ Journaling OFF

Chris

[Chris Tompkins]

I do insert edits on my UVW 1800 all the time
FWIW

Chris

[Chris Tompkins]

DV50 is the higher quality codec

[Chris Tompkins]

Have u recorded some clips b/4 you logged and tried batch capture? It sounds like u have clips on the hard drive already. Try “reconnect media” and search your hard drive(s) first to reconnect your media. Then what’s left – choose batch capture to load from tape.
I’ll bet the footage from Fiji looks great…

[Chris Tompkins]

From what I’ve read – DVCPRO 50 is just like DigiBeta. At a much better cost.
If You master on DVCPro. Shoot DVCPro and capture to the Digibeta codec and it’ll look great. FWIW

Chris

[Chris Tompkins]

Select all audio in the timeline and go to:

Sequence
Render Only
Mixdown

[Chris Tompkins]

Did you “Mix Down” your audio b/4 playback?
I don’t think the volume of your audio would effect playback…

Chris

[Chris Tompkins]

I don’t think Disk Utilities will allow repair permission on anything but your mac internal hd