Vince Becquiot
Forum Replies Created
-
What they mean is that they a accept 1080i signal.
They obviously compress it, amd sell it on the cheap on time for the Superbowl ;).
True 1080i HD sets are still not affordable for most consumers.
Cheers,
Vince
-
I hope I got your question right. You are following the paint strokes with another layer right ?
So, that other layer should be your target.
I usually pre-comp the paint strokes layer, apply motion tracking to it. Place the tracker on the very tip of the stroke.
Select the layer tracking the stroke in ‘Edit Target’.
That should work…
Vince
-
Well, I don’t think you can actually make a square tip, just a flat thin one by changing the settings in the brush palette…
May I ask why you need that particular tip?
You may be able to achieve the same effect with a mask, stroke, or just a simple expression.
Vince
-
Well, I don’t think you can actually make a square tip, just a flat thin one by changing the settings in the brush palette…
May I ask why you need that particular tip?
You may be able to achieve the same effect with a mask, stroke, or just a simple expression.
Vince
-
Look no further than right below, where you found motion sketch.
‘Window > The smoother’
Cheers,
Vince
-
I have this problem on one of my workstations, it has a cordless keyboard. Could be a keyboard or driver issue issue though.
Not sure if it is related.
Vince
-
I agree with Mylene, and I really wouldn’t be too worried about it.
It has been said by many before, plugins should never be looked at as the main focus of your composition, just a way to improve it; Use them as you would use your sound track, then again, again I’ve seen sound tracks with white screens…
I see many many people just use 3d stroke (For eg.), without any planning, and then just build around it hoping that better things with come with it. And all we usually end up seing is… a good commercial spot for trapcode.
I know this is starting to look like an oversused argument too, so I’ll stop here 😉
Vince
-
Make your first brush point, hold shift and make your second point, it will connect the 2 points.
Vince
-
Make your first brush point, hold shift and make your second point, it will connect the 2 points.
Vince
-
Have you looked at the ‘Total Training’ DVD’s ?
If not, it’s a must have in my opinion.
Vince