Replies – Forums – Tylor Larson

Forum Replies Created

Page 1 of 15

1 2 … 15 →

Tylor Larson
December 2, 2013 at 4:01 pm in reply to: After effect comp size to match C4d object

figured out…
Tylor Larson
April 18, 2013 at 2:22 pm in reply to: flattened t-shirt pieces as texture for 3D model

you could look a blender… it is an free, open source 3d program.

ty
Tylor Larson
April 12, 2013 at 8:45 pm in reply to: emulating this transition

is there any other way to do this inside of AE… i want to have something i can control and modify.
Tylor Larson
April 12, 2013 at 8:29 pm in reply to: emulating this transition

that is funny. i was looking at this company yesterday. our IT guy brought back a couple samples from NAB. Rampant design tools make some great stuff.

Ty
Tylor Larson
April 11, 2013 at 4:54 pm in reply to: How to cookie cut object

if you use the lasso tool on the paths you want to keep and then go to selection/ invert and hit delete twice you should have what you want.
Tylor Larson
April 10, 2013 at 9:49 pm in reply to: swinging motion… how to i set the start value that isn’t Zero

that works. aways struggle with Else if statements. thanks again dan.
Tylor Larson
April 10, 2013 at 9:31 pm in reply to: swinging motion… how to i set the start value that isn’t Zero

ok one last issue… how do i delay time… aka offset the start time of the swinging.
Tylor Larson
April 10, 2013 at 3:27 pm in reply to: Stock Compositing Elements

for the project I’m going to be working on requires a lot of fire, bullet hits, smoke and stuff of that nature. basically compositing fx clips into footage. besides it’s a ton of fun trying to force a square peg into a round hole.

after some searching i did find these guys as well

https://www.fxelements.com
Tylor Larson
April 10, 2013 at 3:22 pm in reply to: How to cookie cut object

i dont have cs6 but i did this in cs5.5.. unless something changed between the versions.

so i made some Lines…. AKA open paths… i then made a circle. just like you did

i then selected everything

in the path finder i use the outline button… i then applied a new stroke color and used the hollow arrow to delete all the extra stuff i didn’t need. i also switched over to outline mode to make sure i deleted all the extra elements. this should leave you with a set of lines outside the circle that are still open paths.

Ty
Tylor Larson
April 9, 2013 at 7:52 pm in reply to: import 10 bit Tiff sequence

what does the error message say? where does this file come from? does it have to be 10 bit?

Page 1 of 15

1 2 … 15 →