Robert D'alexis
1
COW Coin
Forum Replies Created
-
Hi
I also experience the same freezing issues using a combination of an older BM card (the Decklink Extreme 2 ) and CS6, so this is definitely not machine-related. The only way out is a reboot as you described.
The problem then disappears only to reappear a few days later. -
Please tell us where you found the drivers on Matrox’s site.
The above link points to the 6.1 version which is only suitable for CS5.2. -
Thanks again for taking the time to respond, Tim.
I’ll be only too pleased to translate your posts for my friend who doesn’t speak good English.
Like me, he is a native speaker of French but hopefully your ready sense of humour won’t get lost in translation. 🙂 -
Thanks again for taking the time to respond, Tim.
I’ll be only too pleased to translate your posts for my friend who doesn’t speak English. Like me, he is a native speaker of French but hopefully your ready sense of humour won’t get lost in translation. 🙂 -
Thank you for your insightful comments, Tim.
Actually, I am a PC guy through and through (always have been)and I don’t care about Apple’s software and hardware.
I was mostly curious as to why you said the Z820 would beat anything Apple came up with. I have a friend who is lusting after a Z820 and he has tasked me with gleaning as much information as I can about the machine. -
“Even if Apple releases another Mac Pro (and I think they will), the HP Z820 is going to be a better beast.”
Would you care to amplify that remark, Tim? 🙂
-
Try this instead: select all your cuts on the timeline (ctl + A) then go to Sequence > Apply Default Transition to Selection.
-
“but that was not working lately, but it is under sequence now.”
It works flawlessly on my end.
-
See the post above. 🙂
-
That’s very easy to do: just select all your cuts in the timeline (ctl + A) then go to Sequence > Apply Default Transition to Selection and voila. 🙂
Happy editing