Rajnesh Domalpalli
Forum Replies Created
-
Don and Craig, Thanks so much for replying.
I used the following settings on my PMW-EX1 (given at Bottom).
and also uploaded a clip 46.2Meg 1280×720 QuickTime movie here. The Video was originally shot on 1920×1080 with the settings given below, then imported into FCP and Exported to the smaller format for upload.In the Video you see the Camera Pan along with the Subject.
The trouble I’m having is with the Subject intermittently going in and out of focus/ becoming blurry.
Why is this and what can I do to alleviate the problem?——————————
CAMERA BUTTONS
Iris : Manual
Macro: Off
Focus: Manual
Zoom: Servo
AF/MF Right: Pushed to MF
ND Filter: Off
Gain: Low
Full Auto Light is Green
White Balance: PRST——————————
CAMERA SET
Gain Setup: Low
Shutter->Mode: Speed ShutterSpeed:1/96
EX Slow Shutter->Setting: Off
Shot Transition->Trans Speed: 5 Time/Speed: Speed Trans Curve: SoftStop StartTimer: Off RecLink:Off
MF Assist: On
Color Bar Type: Multi
Flicker Reduce->Mode: Auto Frequencey:50Hz
Zoom Speed-> High:70 Low: 30 Remote: 50
Interval Rec-> Setting: Off Interval Time: 1sec Num of Frames: 1
Frame Rec-> Setting: Off Num of Frames: 1
S&Q Motion-> Setting: Off Frame Rate: 30
Rec Review: 3 Sec
Fader-> Fade In: Off Fade In Type: Black Fade In Time 2 sec Fade Out: Off Fade Out Type: Black
TLCS-> Level: 0 Mode: Standard Speed: +50 AGC Limit: 12db AGC Point: F2.8
Shockless White: 2
White Switch: ATW
ATW Speed : 3
Wide Conversion: Off
Steady Shot: On
——————————VIDEO SET
YpBpPr/ SDI Out Select : HD
YPbPr/ SDI Out Display: On
24P System : 60i
——————————Thanks in advance.
Regards,
Rajnesh -
Thank you… that was what I was searching for.
Rajnesh
-
Hi Michael,
Do you have any videos you could post? Better yet, with and without (the NanoFlash) would be really useful.
There’s been much talk about the EX1’s Rolling Shutter along with Compression causing blur even on slow pans, so it would be great to see if that problem is remedied with the NanoFlash.Thanks.
Regards,
Rajnesh