Rainer Wirth
2
COW Coins
Forum Replies Created
-
Hallo,
ich habe dein Problem nicht richtig verstanden. Kannst du es mir erkl -
What is your native language?
-
Thank you very much ! It works fine, because the clip shows the same colour.
Have a nice weekend
Rainer
-
Final cut 3.0 requires Quicktime 6. Why do you want to change to a higher version? Never change a running system!
Rainer
-
Okay, signal seems all right. Next question: which firmware AJa are you on? Do you have a blackburst signal? Which OSX version? Try to connect Monitor directly with Aja. It could be a sync problem because I don’t know whether PVW 2800, UVW 1800 have a buildt in TBC ? At the beginning I’ve had sync problems (Aja needed at that point a blackburst signal) but the result was sound/picture delays, no jumpy pictures. But the new firmware together with OSX 3.8 works great. (don’t install 3.9!) I didn’t install the brandnew control software of Aja, because I don’t need it. Try following setup: Use composite out Aja as a blackburst signal for one of your Betas (It works most times) Beta must be switched on ext. sync. Monitor should be fine on int. sync. Then check again. At the end you know at least whether it’s a sync problem or not.
Try step by step an you’ll find your problem and you’ll learn a lot about your system you work with.Rainer
-
Hi Gary,
with Sp you use Yuv in/out and 422 connection right? Best quality is component 10bit uncompressed. This should be your settings in FCP apart from the magic 7 frames delay over firewire. Sony 422 control, in out component yuv 10bit uncompressed. Now what deck do you use? I suppose a sony BVW something and how is it connected? What problem exactly is it you have in the outgoing signal? What shows your Monitor? Is the Monitor directly connected with AjA out or is the Monitor connected with BetaSP out, or do you have both options? Tell me. Check signals first. Computer – Aja – Sp.
Rainer
-
Didn’t hear good news of 3.9. I’m glad I’m still on 3.8. Up to now there is no reason to update.
good luck,Rainer
-
I think it’s the same delay than working with AJA (firewire as well) You have to set the user settings in FCP the magic 7 frames, then it’s in sync. The external works in the same way, over fire wire. If the out of sync is constant you can fix it within FCP settings.
Rainer
-
Hello,
there is an easier way. The footage is 16:9. You just have to put the captured 16:9 files in a sequence in 4:3 and you havve an automatic letterbox in the 4:3 Monitor.
When you have edited the piece change settings in the sequence to 16:9 and it shows the sqeezed picture in the 4:3 Monitor.Rainer