Mark
Forum Replies Created
-
Could you not add an expression where the filters position is tied to the position of the parent, and not the position of the layer tied to the parent.
Mark
-
Could you not add an expression where the filters position is tied to the position of the parent, and not the position of the layer tied to the parent.
Mark
-
Is the still moving quickly enough for motion blur to be apparent ?
You may trying adding more motion blur by adjusting the shutter angle in the advanced tab of the composition settings.
Mark
-
It depends on what you are keying. For Chroma keying, keylight is the way to go. I usually can pull a very good key using keylight.
For other types of keying, such as luma keying, I can get good results either using the luma key, or by simply using a transfer mode.
Regards
Mark
-
Have you tried the continue rasterize/collapse transformation button.
Mark
-
I like to tell people that I am an artist. Video is seen more and more as an art form and we are the people who make it happen. The musuem of fine arts here in Montreal has an exhibit of music videos at the moment as they are seen as art form I have to admit though, Creative Genius soes sound way cooler. Multi media Guru sounds pretty cool too.
regards
Mark
-
You can not use back face culling with the glass material. Since glass is transparant it means that the back is always visible. Red uses back face culling to not render the back when it is not in part pointed toward the camera. Since the back is not pointed toward the camera then Red will not render the back, thus causing the problem that you are seeing.
Mark
-
I would do a search as this has been covered quite a bit. Boris has excellent keyers…..I am not sure about FCP.
Mark
-
Although I haven’t done this, I know that you can have more than one tracker. If you set up the tracks correctly, you should be able to have 4 trackers with each one having one of the corner pinner corner points as targets. This should do what you want.
Mark
-
Delete prefs 🙂
When I install an application, I make a copy of the prefs (Once I have them set-up the way I want)…If I get an issues, I just take that preference folder and replace the new one…back to new 🙂