Jordan O'leary
Forum Replies Created
-
Standby – I’m in the middle of a render.
-
Already tried. No go.
-
I didn’t clarify. I had rendered out the CC Sphere into a vid. so now it’s just a square pixel 1080 X 1080 Animation codec vid. BUT! I also tried putting shine on a solid that was smaller than my comp and I put gow bounds on it and it STILL didn’t work.
-
I tried that with an extreme number and on the top layer. No go.
-
I am doing the pre-comp now – and I understand that the solves an immediate issue. But Grow Bounds is useful because you can effect the layer right there instead of opening the comp to futz. I don’t get why it’s not working.
-
I tried uninstalling then reinstalling the 3.0 drivers. It worked. I figure that I had FCP OPEN when I upped the firmware. That could have been why.
HOWEVER… the AJA control panel doesn’t seem to work. In Analogue In – right above it – it says “No Video” in red.
-
Well, I can switch the Render Settings all at one but not the output mode nor can I change the template for the filenames either. I tried it all, if there is a way to change all of the output modes at once please let me know.
-
I found out that since I’m using a MacDrive on my PC that is being read by Mac drive… that for some reason when I put the files on there and restart it looses it’s link for them. Very wierd, it must be thetimecode reference in the filename that’s throwing Macs file structure off. Anyway, I put the files on a NTFS and redid the proxy and away it went. No problems. I tried to find any way around this issue but no go.
-
BTW I’m working in Windows XP
-
It say “Insufficient Source Material’