John Sellars
Forum Replies Created
-
All internal controls, using Virtualforge as the pattern generator. I’ve never seen any PF monitor come this close (not sure about BT’s).
-
I just got the 55VT60 for a client monitor (about $1800 online). Near perfect calibration.
-
I don’t see a preset for 2.40 blanking in Resolve so I made my own based on:
Line 91: first line of picture
Line 490: last line of picture
(399 active lines)In output blanking this happens to be:
Top 139
Bottom 940Correct me if I’m wrong. BMD create a 2.40 preset please!
-
Eric- How about you guys make a piggyback PCIe3 on the SSD connector, so we can drill a hole in the (plastic?) case, and run it to the Cubix…
-
But isn’t external I/O limited to TB 2.0 speeds? Still half the speed of external PCI-e.
-
I have the same problem trying to join clips in a (non-master) timeline that originated from scene cut. I don’t remember this issue in v8.
-
https://www.cinemaquestinc.com/ideal_lumesb.htm#Standard
Or the Pro version if the wall is farther away. You are looking to get about 10% of the luminance of your monitor on the back wall (about 3fL)
Most paint stores will match or cross reference this paint…
-
https://forums.creativecow.net/thread/277/20919
Also check to make sure there are no spaces (%) in the filenames.
-
Easiest way is to add a node in Track Mode. Manual p482. That way you can tweak the overall as you go. If you get to a scene that the overall doesn’t work, put a mark at the head and tail of the scene to isolate it.
Just don’t forget the correction is there!
-
Dave is also a really nice guy who will share his knowledge with you and give you a 9 page before/after calibration report (excerpt below).
https://www.avical.com
(877) 428-4225
