John Perez
Forum Replies Created
-
I’m not sure I understand?
As always thanks so much to you guys…Johnny In Orlando
-
John, two things have changed recently: 1) I didn’t re-plug the drives that have my source clips were on; and 2) I installed more RAM. Is it just a matter of re-aligning the different drives drives to their former letters or pathways? Thanks
As always thanks so much to you guys…Johnny In Orlando
-
I think I was able to fix it in the layer blending on the emboss selection. thanks, sorry for the delaying in confirming reading your message.
As always thanks so much to you guys…Johnny In Orlando
-
Thanks David it does have a scaling move that I used. Thanks, and sorry I didn’t relay this development.
As always thanks so much to you guys…Johnny In Orlando
-
Hi Dave,
I couldn’t figure out your instructions. So what I did was set up new tracks of the out-of-sync part of the multicam then sync’d them up then just created another multicam track. But this time I made the duplicate tracks that you had suggested; so I’ve got it fixed–for the moment! Thanks
As always thanks so much to you guys…Johnny In Orlando
-
Thanks so much, Dave. I’ll do that and get back to you that it worked…
As always thanks so much to you guys…Johnny In Orlando
-
That did it! Thanks so much, Mike…
As always thanks so much to you guys…Johnny In Orlando
-
Excellent. Where is the “creative cow rating button? thanks
As always thanks so much to you guys…Johnny In Orlando
-
Got it; thanks.
(Is it courteous to respond if successful with the suggestions? Like I’ve done here?)
As always thanks so much to you guys…Johnny In Orlando
-
Ha! Exactly. Now I got it. Thanks…
As always thanks so much to you guys…Johnny In Orlando