Joey Burnham
Forum Replies Created
-
Just drag your footage into the “make new comp” icon. How does it look then? If your broadcast monitor can switch to 16×9 do so.
Joey -
Also,
Does it look fine on your computer monitor and only bad on the broadcast? Could be a video out thing.
Joey -
[Mike Alexander] ” Mostly, I wanted to know if anyone has had problems doing this so I know what to look out for – Flickering, Pixelation, etc.”
I’ve never had problems. Technically you aren’t losing any pixels / resolution. All you would be doing is an uncompressed render if you are working in 10 bit. (No render in 8)
Joey
-
[Mauro Moreira] “Michael, do you think i dont have do de-interlace before going to tape(it wont have problems in the projection?) If , yes, this is very good news.”
Wha? If you are going to betacam or “similar” then it has to be either NTSC or PAL, both of which are interlaced….
Joey
-
Exact same issue here as well. I contacted AJA awhile ago about it and they were perplexed and nothing got resolved. Same RGB / YUV conflict issue.
Joey -
Kona card works but the easy way to do it in FCP is just in the motion tab. Double-click your footage and in the distort panel under aspect ratio type in -33. You don’t really lose any quality.
Joey -
Well, FCP doesn’t cost 6 figures, so not really comparing apples to apples.
[Adam Berk] “If we could only get audio playback”
Um, why not? This sounds like a setup problem.
[Adam Berk] “better re-conform abilities”
Not gonna happen any time soon.
[Adam Berk] “Color integrated tape i/o”
Not sure what you mean but I assume color timing on ingest???
[Adam Berk] “realtime playback of rendered material”
This shouldn’t be a problem. As long as your sequence settings match your video, no rendering should be needed. Choose the easy setup that exactly matches your material.
Best,
Joey -
I just want to be on the record trying not to influence your decision. If you have a Flame and Smoke system at the ready then by all means. This isn’t necessarily a problem for everyone. System configuration and setup vary from place to place and I know plenty of people where this isn’t an issue.
Best,
Joey -
It varies generally from output to output. One day it might be four, the next day five…
This isn’t a big deal to me, been waiting for software / hardware updates to fix it for me. 🙂 -
Not hijacking the thread I don’t think as this is related.
Shane,
What to do if the offset isn’t always the same? I’ve been downconverting 1080p 23.98 masterial to NTSC for years and it’s always off by a different number. Eventually I just gave up as the material is for consumer dvd’s and the encoding people don’t really care as they just ingest it anyway.
Joey