Joe Pitkin
Forum Replies Created
-
Yeah, Rip the card out and send it back to AJA.
I ended up talking with an editor who’s spent some time on the system as well. He went “oh yeah, I forgot about that. I think someone turned the phantom power on and blew the output”
Just what I don’t need…
-
That’s exactly what I’ve done to confirm that it’s the analog output off the card and not a cable / breakout box / board input issue.
I get the same noise if I go:
Kona Card -> breakout box -> Board
Kona Card -> Octopus Cable -> Board
It’s not the input on the board, as I’ve used multiple and it follows CH2 Analog.
My gut is that the board got fried at some point before I got here, and no one noticed or cared.
-
That’s possible, improbable but possible, I’ve reserected projects from the same era with no issues, just did one resently that was half beta and half DV, loaded and captred fine. I don’t know if i wasn’t thinking, or maybe someone else had captured the media, I hope that it’s some funky 4.5 to 5 bug, and that installing 4.5 lets me open the file and gives me time code that works, if not i just love rebuilding projects from scratch…
—
pitkin
‘follow my lead and look busy’ -
My vote goes to Fetch
—
joe pitkin -
FCP5 installs Compressor 2.0… so i’m going to re-install 2.0 and see if that makes a difference.
-
okay, done it all.
i’ve tried, having the sequence selected in the browser, and open on a timeline, in/out points set at beginning and end.
cntrl-click the sequence in the browser… ‘sequence conatians no media’
tried the File>export to compressor… with the timeline active and with the broswer active… same error…
did this BEFORE deleting prefs and after, no changes..
I’ll probably end up re-installing Compressor and seeing if that resets something. Just wonder why it worked ONCE and then not again…
—
pitkin -
Wish it were that simple. I’ve tried exporting with no in/out points, in/out set at the beginning and end of a sequence, and even a section of the sequence.