Replies – Forums – Jay Mitchell

Forum Replies Created

Page 1 of 4

1 2 … 4 →

Jay Mitchell
April 26, 2020 at 5:29 am in reply to: Magix AVC render options questions

I would like to have these questions answered as well.

Calling Johnny Ferraro – Come in John 🙂
Jay Mitchell
April 26, 2020 at 5:21 am in reply to: MAGIX Intermediate D1 NTSC Render Issues

Thanks Wayne!
Jay Mitchell
March 26, 2019 at 6:24 pm in reply to: UpRez from SD 720×480 DV to 1080p – Smart Upscale

Thanks Wayne…

I downloaded the Beta and will check it out!

Jay
Jay Mitchell
March 25, 2019 at 11:46 pm in reply to: UpRez from SD 720×480 DV to 1080p – Smart Upscale

On the Quality Tab, I have adjusted it to Magic Sharp as John Rafrono recommended. But I also see a slider for further sharpness. If you also need to adjust Saturation, which Video FX filter do you recommend using?
Jay Mitchell
March 25, 2019 at 10:03 pm in reply to: UpRez from SD 720×480 DV to 1080p – Smart Upscale

Yes. I found out about the BCC Image Restoration Unit after I made the post. I did download the trial and am testing it now. I expect that it will do a good job. I watched John Rofrano’s UpRez video again to make sure that I get the settings correct.

How much of what BCC UpRez does can be created in Vegas Pro using the Smart Upscale?
Jay Mitchell
March 1, 2019 at 10:48 pm in reply to: Placing Markers at Musical Beats

That was quite an interesting tutorial!
The Vegas Pro layout has come a long way since version 8 ☺
Jay Mitchell
February 28, 2019 at 10:38 pm in reply to: Vegasaur Transcoder Issues

Solved!

It is not good enough to just click / “highlight” the preferred Rendering Format.
The “check mark” next to the format must also be highlighted.
Jay Mitchell
February 25, 2019 at 2:12 am in reply to: Making Regions from Markers – Automation

Just found that Vegasaur can do this.
Jay Mitchell
February 16, 2019 at 7:58 pm in reply to: Outputting or Converting to .mov

I rendered the 3 minute project to the MAGIX Intermediary 422 1080p and it produced a 3GB .mov file. I uploaded that to the client as I was at the deadline. The rendered video looked great. But ,much too large of a file.

I then rendered a h.264 mp4 file and it produced a file of 300MB and also looked great.

Before reading your posts today, I was thinking that I should have found a way to convert the mp4 file to a mov.

I am not familiar with how to change the command lines as you described. Is there any way that you could produce a tutorial on that procedure? Or, write a set of step-by-step procedures for me to see how it’s done.

Thanks,

Jay
Jay Mitchell
February 16, 2019 at 12:12 am in reply to: Outputting or Converting to .mov

George – thank you for the replay

I need to give them a clean demo video of the project.
They specified the h.264 .mov

I am assuming that they are MAC users. FCP etc…

So, with all of your expertise, what would you suggest I give them that will be clean and play on their MACs.

I’m not a techie, so most of what you previously said about the output qualities is over my head.

I am in crunch time, having had to rebuild the lost work from yesterday.

Page 1 of 4

1 2 … 4 →