Replies – Forums – Jason Kennedy

Forum Replies Created

Page 1 of 2

1 2 →

Jason Kennedy
January 5, 2009 at 3:42 pm in reply to: transition issue

Thank you Tom

The link was very helpful, I greatly appreciate it.

Jason
Jason Kennedy
January 3, 2009 at 2:42 am in reply to: External Hard drive issue

Walter,

When powering down, I eject the external hard drive from my finder window, once the lacie hard drive is no longer on my desktop, I pull the plug, which turns the hd off. That is the proper shut down method, correct?

In the past though, there were a few times when the plug was pulled from the computer while the hard drive was being used ;-(

Thanks for the input. For now, I’ve been leaving the hard drive on, connected to my computer. Also one other thing, am I not supposed to use the same port that I use when importing footage from my camera then disconnect from the camera so I can transfer footage to my hard drive? I received a post that kinda made it seem that I was doing something incorrectly.

Jason
Jason Kennedy
January 3, 2009 at 2:32 am in reply to: External Hard drive issue

Rafael,

To import footage, I use my camera (hvx200) and connect through the usb port, can that be damaging to either computer or camera?
Jason Kennedy
December 21, 2008 at 4:04 pm in reply to: audio sample rate

Thanks Tom,

I see that my tape audio rate is set to 32k whereas my capture presets are 16k. If I change the capture presets, will that effect the other clips audio? I will try doing so, I just wanted another’s opinion before I do something like disrupt the other audio files.

Jason
Jason Kennedy
December 11, 2008 at 1:08 am in reply to: locating the serial number on Final Cut Studio 2

Thanks everyone for the response, I sometimes amaze myself, I actually put the serial number booklet in a folder that I forgot to label!

May you all have a blessed holiday

Jason
Jason Kennedy
September 19, 2008 at 6:21 pm in reply to: Export FCP clip to AE

Rafael,

I believe my codec is DV NTSC 48 kHz, should I change it?
Jason Kennedy
September 17, 2008 at 9:16 am in reply to: Special Effects

Hey Zane,

I realize that spacing is crucial in order to do the trick. And I agree that the camera must be in the exact same position for both shots. I plan on setting my camera outside of the car on a tripod looking through the passenger front window seat. The problem is that my character in the passenger will be moving around to the point that he will “lose an arm” whenever he crosses the cropped clip.

I have a couple of days to mess around before the shoot begins, will keep at it.

Thank you for the words of encouragement

Jason
Jason Kennedy
September 16, 2008 at 10:54 pm in reply to: Special Effects

Hey Matte,

Thanks for the input. I tried that way but it creates a very distinct split between my clips. I appreciate it
Jason Kennedy
September 16, 2008 at 10:52 pm in reply to: Special Effects

Thank you Stephan for the advice, I’ll give it a try. I have AE 8 but am still learning it.
Jason Kennedy
January 27, 2008 at 12:11 pm in reply to: speeding up clips

thanks for the assistance, will give it a try

Page 1 of 2

1 2 →