Replies – Forums – Gracias

Forum Replies Created

Gracias
September 21, 2005 at 1:02 pm in reply to: General Error

Hello,
Usually I copy it in my Hard disk (SCSI) But still I get that error.

please let me know.

Regards
Gracias
August 19, 2005 at 5:28 am in reply to: Green needs render.

Hello,
I was sure of Light Green which is on the timeline needs to be render. Do I have to do the same even for the Dark Green before outputing to the tape.

Regards

Srini
Gracias
August 19, 2005 at 5:26 am in reply to: Green needs render.

Hello,
I was sure of Light Green which is on the timeline needs to be render. Do I have to do the same even for the Dark Green before outputing to the tape.

Regards

Srini
Gracias
June 21, 2005 at 4:52 am in reply to: Media Offline

Hello,
I did all this again, but no results.

Any more solution on this.

Regards

Zishan
Gracias
June 20, 2005 at 5:16 am in reply to: Codecs

Hello,
So shall I assume Whatever is there in the Bracketi.e. Targa YUV (8bit) Balance Pro analogue along with the Targa is also Cinewave codec. Otherwise rest is Apple Codec.

Actualy one of my support engineer told me so.

Please confirm. Thankx for u r response

Regards

Gracias
Gracias
June 19, 2005 at 6:41 am in reply to: Codecs

Hello,
Thankx for the reply.

I looking for Cinewave Codec for Cinewave. As I am using Cinewave card on my MAcG5

So ih my Easy Set up and in Audio Video Setting what it has to be in order to get everything Cinewave codecs.

Regard

Gracias
Gracias
June 14, 2005 at 5:02 am in reply to: FCP speed

Hello,
Yeah I am looking onthe ext monitor and the jitter is making it visible clearly.

If I have to change the ram which one I should go for.

Thanx

Najeeb
Gracias
June 14, 2005 at 1:14 am in reply to: FCP speed

Hello,
Thx Michael, Well I did batch capture n the duration of the each clip is not exceeding 10mts either.

I did evrything like formatting, My OS is also 10.3.5

If I change the RAM will it resolve the issue. Because I have identical FCP machine it is not coming over there.

Regards

Najib
Gracias
May 6, 2005 at 6:28 am in reply to: Trim

Hello,
Actually when I drag my cuts from the sequence through mouse when I m on trim mode. It doesn’t happen at all. Otherwise it happens by keyboard shortcuts.

Seems this is a serious issues.

Regards

Zishan