Replies – Forums – Don Connors

Forum Replies Created

Don Connors
November 6, 2009 at 12:35 pm in reply to: Installed the Pro App update but still running 7.0??

I found the fix on this forum here:

https://forums.creativecow.net/thread/8/1059834#1059981

Thanks to all!!

Don Connors
http://www.dcp.com
Don Connors
November 6, 2009 at 12:34 pm in reply to: Weird little playback bug

this fix solved my problem… thanks to all!!!

Don Connors
http://www.dcp.com
Don Connors
November 6, 2009 at 11:33 am in reply to: FCP 7 desktop preview not synced

I am having the same problem after installing Apple Pro Apps 2009-01.

Here’s an entry from my console messages – maybe it points to a solution?

“11:05:09 5:56:42 PM Final Cut Pro[346] Warning once: this application, or a library it uses, is using NSQuickDrawView, which has been deprecated. Apps should cease use of QuickDraw and move to Quartz.

Yes, but how?????

Any thoughts out there?

Thank you, in advance.

Don Connors
http://www.dcp.com
Don Connors
November 2, 2009 at 1:02 pm in reply to: Installed the Pro App update but still running 7.0??

whoops! Spoke too soon – still have problem of jumpy video in Full Screen mode after Pro Apps 2009-01 install. Same files played in QT do not jump… also, older EDLs now jump…

any thoughts out there?

Don Connors
http://www.dcp.com
Don Connors
October 29, 2009 at 12:53 pm in reply to: Installed the Pro App update but still running 7.0??

this discovery also seems to have fixed my “jumpy” video in Full Screen mode after my install of Pro Apps 2009-01 – THANKS!

Don Connors
http://www.dcp.com
Don Connors
May 30, 2009 at 10:09 pm in reply to: Hmc 150

look at Voltaic…

good luck

Don Connors
http://www.dcp.com
Don Connors
July 13, 2007 at 8:47 pm in reply to: crazy multiclip behavior in FCP 5.14

Hi, Dan:

Yes, I was incorrect! You should be writing manuals for Apple – you just boiled down about 15 pages of confusing tech-speak into a usable formula. Thank you!

Don
Don Connors
July 13, 2007 at 5:53 pm in reply to: crazy multiclip behavior in FCP 5.14

Hi, Dan:

Thanks for your quick reply, but your suggestions did not solve the problem. The whole multiclip thing is acting very erractically on both systems.

When I double click the multiclip in the browser, it loads only into the Viewer, not into the Timeline as indicated in the pdf manual on p II-278 “To make multiclip cuts in real time using the Viewer”…

If I load the Mclip into the Viewer, then also drag it from the Browser to the TL; then un-enable it as per your suggestion, the Viewer Mclip plays fine, but with no sound.
If I re-enble the Mclip in the TL, then I hear audio; but when I try to cut by choosing a different angle, the system stops. (Laissez les bons temps roullez)

Are there any cutters out there who do NOT have multiclip problems?

Thanks, in advance.

Don