Replies – Forums – Chad Smith – Page 9

Forum Replies Created

Page 9 of 17

← 1 … 8 9 10 … 17 →

Chad Smith
January 20, 2014 at 8:49 pm in reply to: Wrong parts of clips conform in Resolve via FCPX XML (multicam)

Exporting full res reference movies of projects, then gonna roll the dice!
Chad Smith
January 20, 2014 at 8:27 pm in reply to: Wrong parts of clips conform in Resolve via FCPX XML (multicam)

Dennis – Thanks so much for your reply. Purchased Xto7 today and it has worked on the multicam clips that contain two clips, however it is not seeing cam A + B of a 4 camera multi clip. Sent the issue to the Xto7 folks and they asked for my xml file five minutes later, so they seem to be on top of it. However in the mean time I may upgrade to Mavericks and 10.1 Was hoping to hold off till I got a few projects out the door however this issue is keeping me from doing that 🙂 My multi clips were made the “proper” way btw.
Chad Smith
January 20, 2014 at 5:25 pm in reply to: Wrong parts of clips conform in Resolve via FCPX XML (multicam)

Has anyone found a solution to this? I have a multi cam concert and another project that uses multi cam clips in FCPX. Multiclips are not coming into Resolve 10.1 at all. Exporting from FCPX 10.0.9
Chad Smith
December 9, 2013 at 9:21 pm in reply to: FCPX Multiclip question

Got it working if I drag the multi clip into the timeline. Would not work cutting into the timeline for some reason.
Chad Smith
September 3, 2013 at 7:05 pm in reply to: Modify TC Greyed Out

Thanks for the reply Kevin. I am new to PP. How can I find out if the 5D files had timecode? All the clips come in with start times of 00:00:00:00 so perhaps not. Used to doing this in FCP7.
Chad Smith
August 7, 2013 at 4:12 pm in reply to: Reading LTC in 9.1.4

Thanks Dwaine – That does seem odd. I will try again with a fresh clip.
Chad Smith
August 7, 2013 at 3:43 pm in reply to: Reading LTC in 9.1.4

Hi Dwaine – Downloaded 9.1.5 for Mac and tried it again, however I still can’t get it to work. Perhaps I just need to wait for version 10 to be released! 🙂
Chad Smith
July 22, 2013 at 3:42 pm in reply to: Can’t select make multicam clip in 10.0.8

Seems to be working fine this morning. another Hmmm.
Chad Smith
July 19, 2013 at 9:14 pm in reply to: Can’t select make multicam clip in 10.0.8

thanks Brett will give that a shot monday!
Chad Smith
July 19, 2013 at 9:13 pm in reply to: Can’t select make multicam clip in 10.0.8

David Thanks I will try that on monday once I track down the original!

Page 9 of 17

← 1 … 8 9 10 … 17 →