[Ben Dittrich]

No Caching or Proxy Modes are enabled.

If i do enable Caching or proxy, the problem persists…
If i go to half res, the problem also persists.

Resolve is running Realtime at 25fr… my monitor output is fine… just the Gui Viewer ticks out.

https://www.dropbox.com/s/p2o6vn37ocg0v3v/Resolve%20Hiccup.mp4?dl=0

[Ben Dittrich]

The picker works in other Projects.

Everything is selected the correct way… it just doesn’t react with the mouse when i want to pick or grab anything.

I tried to archive and reload… didn’t work.
Installed the older Version… didn’t work.
Loaded the System Config… didn’t work

In other Projects everything is fine.

[Ben Dittrich]

Hey Everybody.

Solved the Problem.

There was 2 Seetings which didn’t match the edl

In Config Menue and then under the source Tab:

Make sure for: Master Red Decoder Settings that your timecode is set to the correct timecode your edl is edited with.
Check in the Browser if the start tc matches the edl tc

My default seeting was “Camera” the correct one for my purpose is “Absolute”

But this doesn’t help when the system is looking at the wrong reel names, like in my case.

So i changed in the Config Menue the Timeline conform options:

Use timecode: Embedded in the source clip
And then:
Assist using reel numbers from the… i switched to: Embedding in the source clip file.

After that everything matched the Informations which came along from the Avid edl

Thanks everybody for help & I hope that helps if somebody has a similar problem.

Greetz

[Ben Dittrich]

I checked everything, the edl is fine and the names are all correct.

Even when i change them manualy for the file and in the edl it will not work.

I realy don’t get it….

How do you guys import Red Material? Whats your Workflow, also with edls, or?

Benjamin Dittrich
Digital Artist
C.3 Frankfurt
SilverSurfer79@gmx.net

[Ben Dittrich]

Hey guys,

the setting works… i check it with the captured clips and the exported ones.
I also calibrated my System on 2.2 Gamma.

But something strange happens in Squezze…. the exported clips from FC, which i want to compress, gets darker.
I checked all the settings, everything is fine.
When i compress the same clip in Compressor, the brightness is fine.

Well i could say, f*** Squezze and go over Compressor, but Squezze is a hell of a good compression Programm which produces small clips with a very good look.

You guys got any idea, or Tip on that?

Greetz

Ben

[Ben Dittrich]

I’am capturing and exporting with AJA “uncompressed 8-Bit 4:2:2”

Ben

[Ben Dittrich]

Hey Brad.

I’ve got the exact same buging problem as you… but didn’t find any solution… how is it with you, since your posted, did you get an solution?

Greetings

Ben