Replies – Forums – Samuel Boulton

Forum Replies Created

Page 1 of 2

1 2 →

Samuel Boulton
April 22, 2011 at 4:47 pm in reply to: Photo Montage Animation

Thank you Joseph and David for your quick reply, but most important, your expertise. Your advise worked as slick as snot.

David/Teacher, I’ll complete my assignment/challenge and report back to you regarding copying the keyframes from a clip that’s one length and get them to work over the length of the new clip.

Stay tune teacher!
Samuel Boulton
February 25, 2011 at 5:21 pm in reply to: HD Compression for Broadcasting

Which preset in Compressor are you referring too? Is it “Web Videocast / MPEG-4 – Webcasting”, with width 320 & height 240? Or is it the one I use mostly for Youtube which is, “QT 7 compatible / H.264 LAN Streaming”?

thk, sam
Samuel Boulton
February 25, 2011 at 4:49 pm in reply to: HD Compression for Broadcasting

HD is not a requirement. They prefer MPEG4, but not required. Most access producers deliver their content on DVDs, but usually 30 minute episodes. I also have a program called “MPEG Streamclip” with other options. What would you do?

Thk, Sam
Samuel Boulton
April 1, 2010 at 2:29 am in reply to: Multi-Clip Editing

Thank you Alan,

Your FCP multicam sync document was very helpful.

Best regards,

Sam Boulton
Samuel Boulton
February 3, 2010 at 10:23 pm in reply to: Transparent Background

Mark,

I’m bewildered…

When I started this help needed thread, the words in my project were not transparent. I tried many different setting before starting this thread. I also changing the Channel menu settings to ‘Alpha’ as you suggested, and it still had a black background.

After sending you the file for analysis, I closed Motion3 and FCP6. When I relaunched FCP6 and imported the assets to make the requested screen shot, the file is NOW working. The Motion file background is transparent. I don’t know what to tell you, other then thank you for your efforts and your patience. Perhaps FCP’s timeline had a glitch, I just don’t know…

I apologize if I wasted your time. Thank you once again!

Sam
Samuel Boulton
February 3, 2010 at 8:45 pm in reply to: Transparent Background

Below is the link to the file for downloading.

526_webelievepromo.motn.zip
Samuel Boulton
February 3, 2010 at 8:21 pm in reply to: Transparent Background

Thanks Mark for the extra efforts offered. I’m certain you have better things to do with your time. This was my first posting, so I hope I did it correctly.

Sam
Samuel Boulton
February 3, 2010 at 7:48 pm in reply to: Transparent Background

The Channel menu had ‘Transparent’ selected on my last save. I switched it to ‘Alpha’ and saved as a new file, still black.

Any other suggestions would be greatly appreciated.

Thk
Samuel Boulton
February 3, 2010 at 5:46 pm in reply to: Transparent Background

Mark,

Thanks for your quick response. I saved the Motion file and imported it directly into FCP, background still black.

Perhaps I did something wrong. The Motion project file I imported has the extension, ‘.motn. My background settings are still set to transparency.

Is there something or a setting I should recheck?

Thanks,
Sam
Samuel Boulton
October 20, 2009 at 6:59 pm in reply to: Ken Burns Effect for Montages

Peter,

Outstanding! Thank you for the heads-up on this freebee…

Sam B.

Page 1 of 2

1 2 →