[Robin Probyn]

Oh, Mark… my box does have a Panavision sticker on it. Am I trying to look too cool?

Not if its on a Panavision camera .. yes if its infront of a Z1.. 🙂

[Robin Probyn]

and someday, the cards will be both better and cheaper than tape.

Yes then I,ll sell/use as door stop.. my HDX900… until then like everyone else I wont.. Wasnt it Gilet that gave away the razor blades to make people buy the actual razor..

[Robin Probyn]

Ok thanks..!

[Robin Probyn]

I posted before the same question re my HDX900… although it seems to be the same for all of them.And one soundguy told me this is always the way with Pana camera,s ??? going directly into the camera.

If I go direct into the camera,the sound dial on the camera side has to be way down.. not even near 40%.
Usually I get sound from the sound persons mixer.. no problem and the dial in the (normal) position..
So I,d never noticed it till recently.. better than low I guess,was a bit unnerving setting the level so low.

[Robin Probyn]

Dont that camera,but my HDX900 has two shutter menus, shutter speed AND also shutter select.You can have a shutter speed selected,but if its not switched on,in the other menu,if wont work..

Just a thought…

[Robin Probyn]

Thanks as ever! Iam off to the beach! have a good xmas sir.

[Robin Probyn]

Hi Ty

Yes merry xmas! hope your not in too much snow!

So if you have line level into the camera say from a mixer… the preamps wont be used? so a mic level input will be boosted to line level ? because its better quality ?

Thanks again

[Robin Probyn]

What is a pre amp… and what is its function.. ?

Thanks

[Robin Probyn]

Thanks for the info..

Merry xmas!

[Robin Probyn]

Hi there

Thanks for the advise… the signal is very hot coming direct into the camera so have to turn levels way down on the camera… but works ok. Wondered if putting say -6db attenuation into the transmitter would help… this is with ordinary talking levels in interviews.

So your advise is to stick with putting the camera levels down..

Thanks