Richard Cardonna
Forum Replies Created
-
It hurts you to know about the 2 million new users with a 45% increase in Mac so you change the subject. Ah some of these apple fanboys when will they see reality?
Ric
-
Thanks for the info. It looks like ppro is aiming for fcp/avid and A/E to autodesk. Kinda makes you wish CS7.0 was here
Richard C
-
If I am close to NAb I never buy anything specialy software because almost always happened is what happend to you. Sony,Adobe and others usualy announce upgrades at NAb. But if I really needed it badly then I would have had to buy before.
Hope it works out for you.Richard
-
Thanks Walter I have a clearer picture now. I will wait till Adobe makes A/E more super than its now.
Richard
-
I am just curious and in a speculative mood. Smoke is not right for me I don’t do 3d comps.
But I do consider that the combination of PP,PS,A/E & Audition through dynamic link are for all intent and purpose 1 app.
With Wesplate at adobe who knows if they will even be more tight intergration.
It would not be to far off to think that autodesk has seen this relation and now with a 3d tracker 3d extrution in A/E what is to stop Adobe from including more 3d stuff like 3dcomp all they got to do is add PS vanishing point to A/E and you got a few notches over smoke just there.
Can you imagine A/E with smoke capabilities on a highend HP/Promax it would really smoke.
So I ask what else besides this would a/e need to qualify as a smoke killer?
Am I reading to much into this?
RC
-
Don’t worry its me being fasicious. hmm a 30film with 20 beer. I prefer a 20 beer
-
So Dos XX beer is really Dos 20 beer? Naugh
And xxx filme are 30 films?
-
so basicaly A/e can do most of what Smoke does except the node thing.
(editing through PPro)RC
-
No I don’t like nodes they confuse me. Just hope that AE is on track to overtake smoke.
Richard C
-
Tell me about it, I had edit and combustion and less than a year the prices went down (plus paint & Effects)and then eol, combustion sometime latter. So I am very weary of Autodesk much more using an Imac (how long will any of these be around)
But since A/E now haw a great 3d traker and 3d extrusion I percive that they are going after smoke. And would want to know how far they got to go to at least match it.
Richard C