Forum Replies Created

Page 2 of 5
  • Philip Fass

    March 10, 2012 at 1:09 am in reply to: field monitor for HPX370

    Yes to which?

  • Philip Fass

    December 19, 2011 at 9:18 pm in reply to: Diconic battery problem?

    Thanks. Will those charge on my AB charger?

  • Philip Fass

    December 19, 2011 at 8:28 pm in reply to: Diconic battery problem?

    It won’t power the camera long enough to set anything. The warning light and sound stay on for about 5 seconds, then it shuts off.

  • Philip Fass

    November 15, 2011 at 6:36 pm in reply to: Neumann vs Sanken shotguns

    Eric, thanks. This is why I don’t totally trust the samples I heard on that website. But if you have time, I’d be curious about your comments re the first set of CS-3e and Neumann 81i male, on-axis, indoor voice samples. Maybe they’re not representative of the Sanken’s sound?

  • Philip Fass

    October 17, 2011 at 8:06 pm in reply to: any opinions on this kit?

    I wish I could try several, but I live hundreds of miles from the nearest dealer.

    I will say that in the comparison test Dan Brockett did several years ago, which included Sanken, Schoeps, Senn, etc., the one that sounded consistently best to my ears, both on and off axis, was the Neumann 81i. However, DPA wasn’t in the test group.

  • Philip Fass

    September 30, 2011 at 3:02 pm in reply to: is this a safe bit rate?

    As I feared. So you’d go with 6.0? I don’t want to lose sleep over this project…it’s very low budget.

  • Philip Fass

    March 13, 2011 at 5:40 pm in reply to: P2 card reader?

    I’ve read some posts that say the $350 Panasonic card reader offers a faster transfer rate than camera-to-ext. hard drive connection.

    I can’t figure out why this would be, since the limiting factor would seem to be the speed of USB2. What is it about the card reader that makes transfer faster?

  • Philip Fass

    March 10, 2011 at 6:38 pm in reply to: accessories for 300/370

    Can you give me an example or link to a specific accessory that comes ready to mount into one of those threaded holes?

  • Philip Fass

    March 5, 2011 at 10:36 am in reply to: off-brand batteries

    Good suggestions. Thanks. But I need to replace a Dionic 90, for which I already have an AB charger. Unfortunately, buying an aftermarket battery + charger costs as much or more than a Dionic.

  • Philip Fass

    March 4, 2011 at 1:29 pm in reply to: off-brand batteries

    Should i rule out that there would be a non-AB branded battery that uses the AB charger?

Page 2 of 5

We use anonymous cookies to give you the best experience we can.
Our Privacy policy | GDPR Policy