[Paul Turlick]

believe me….I know. Problem is it would be deserved. I figured at least I fessed up.

[Paul Turlick]

My penance……

DOH!

Operator error.

Broke the first rule of troubleshooting by not checking my connections. Breakout box cable somehow became loosened. Seems to have fixed the issue.

As always thanks so much for the quick responses.

-Paul

[Paul Turlick]

will do. strange thing is I outputted to digibeta with no issues….

[Paul Turlick]

Thanks Jeremy

[Paul Turlick]

ever get a chance to see if it’s fixed Walter?

thanks

[Paul Turlick]

Thanks Walter. That’s capturing via the Kona and not via FW correct? Perhaps the issues I was having was capturing via FW to a FW drive on the same bus. I can’t exactly recall the setup.

[Paul Turlick]

Hi All-

I heard back from Kona and they said that I need to have one slot empty in the bus that the card is in. Meaning it’s OK to have the Atto in slot 4, the Kona in slot 3 and slot 2 is to be empty. That could be why I’m getting the error but I have to wait till Monday to check. That said, I’d have to yank my FW card and that takes my capture to a FW drive out of the mix as I was having issues trying to capture to the drive on the regular FW bus.

I know the response will be “why don’t you just capture to your SCSI RAID as you have the Atto card?”. Well, sometimes ( alot of the time) the FW just gives me a lot less hassles and more stability so I use it for some workflow situations. Do I really have to start yanking cards each time I want to use a different storage scenarios?

Any thoughts/setups/workarounds would be greatly appreciated.

-Paul

[Paul Turlick]

Thanks Bob. I think I’ll pull the FW card out and see but I was hoping to avoid it. As far as drivers go, the FCP update was done well before the new drivers were installed (today). Perhaps an uninstall and reinstall would be worth a try anyway.

Thanks

[Paul Turlick]

Thanks Bill. It’s not causing a problem but I’d love to figure it out. The source audio is 48k as referenced by my DSR-40 front panel and the properties of the captured clip in FCP. The only difference I can see is the audio format incompatibility.

Hmmmmmmmmm….

[Paul Turlick]

I want to change it because I’m getting a warning saying the source clip’s settings and the seq ssettings are not compatible thus POTENTIALLY causing sync issues. Don’t know which manual you mean as after all these years I’ve got about two dozen. Please specify..

Also- I SHOULD be able to change the parameters of the audio in the seq settings no???

Thanks-
Paul