Olly Lawer
Forum Replies Created
-
Thanks. Interestingly I went to all huge effort of resizing and all the ad asked for was a YouTube link, no mention of aspect ratio!
Olly Lawer
-
Yep. Tried with and without all buttons.
Olly Lawer
-
PS – Just tried bringing the footage up a level and applying the tracking data. The 3D camera now works a treat, but the footage looks blurred when bringing it to it’s original resolution to fill up the screen. This shouldn’t be the case as this is the original resolution.
PPS – I’ve tried using the ‘preserve comp when nested’, but I still get the same issue when adjusting the anchor point. I cannot get the footage to zoom full screen.
Olly Lawer
-
Hi,
Thanks. The first bit did. If you could give some step by step instructions that would be absolutely brilliant. If you have time. Not sure what these buttons look like, so going to read the help for Mocha too.
Olly Lawer
-
Genius! When you are so close to something it’s hard to see you wood from the trees!
Now just to figure out how to mask the image and have the corner pins at the edge of the mask.
Thank you!
Olly Lawer
-
Yes, I had a play but couldn’t figure out how to make it work with a corner pin effect. I am trying to have some footage within some other footage (replacing a blank video screen within a video card to make it look like the video we shot is playing within the card).
Olly Lawer
-
Totally agree. SxS cards are sooooo expensive compared to an alternative which is ‘as reliable’ by any standard (meaning those that use it haven’t had a failure as far as I have scoped out).
To match the number of cards I have with SxS cards would cost half the camera cost again. £3k I reckon.
Olly Lawer
-
Brill. Now purchased. Thanks.
Olly Lawer
-
Well Creative Video recommend the MxR over the Sony MEAD one. Strange. They get a lot less issues.
The question is, better than Kensington adapter?
Olly Lawer
-
Ah, I see! OK will take some getting used to!
Thanks.
Olly Lawer