Mike Merkwan
Forum Replies Created
-
Thank you David!
-
Thanks alot guys. You never fail me, and im constantly learning from you. I really appreciate it. Take it easy. -Mike
————————————————–
the rats are getting fat while good men die…
http://www.myspace.com/battleflask -
You mean not have the dual link option enabled or not have the cables hooked up at all? We’re not in dual link. Thanks Jeremy.
————————————————–
the rats are getting fat while good men die…
http://www.myspace.com/battleflask -
Hey Michael thanks for the response. I tried to export out of compressor using the de-interlace in frame controls and it didnt work. I was really surprised because compressor usually takes care of anything like that…
————————————————–
the rats are getting fat while good men die…
http://www.myspace.com/battleflask -
My key-frames we re adjusting for interlaced monitor playback, if you find yourself in the same situation copy your sequence and change the field dominance to none (p). the quicktimes came out great. I feel like i got beat up. That sucked. Hope this helps some people out there. Keep cuttin.
————————————————–
the rats are getting fat while good men die…
http://www.myspace.com/battleflask -
I tried single link as well and that did not work. I think the tri level sync was probably the issue. So if i had a sync the proper way to bring in 1080 29.97Psf is through the 1080i 29.97 (single link) option? The deck guys were saying i didnt need a sync to capture, but just to lay off. So i ruled that one out early. Not having a tri-level sync does sound like the problem to me. Thank you guys for everything!
————————————————–
the rats are getting fat while good men die…
http://www.myspace.com/battleflask -
ya I was rolling dual link. The footage is 4:4:4.
————————————————–
the rats are getting fat while good men die…
http://www.myspace.com/battleflask -
Ya i tried to capture with 1080i several times. The deck started cranking on the drums and eventually it would spit out the tape with the “Bad Drum” error. The deck would play the tape fine so I know the deck was setup properly. It was on the Final Cut / Kona side. But I tried everything… I have never had a problem w/ any HD capture w/ HD CAM SR. I actually updated the Kona software right before this project. In the capture window I could see the footage but it wouldnt lock and it was VERY jumpy. I couldnt capture anything… it would drop frames immediatley.
Basically the tape would run fine in the deck until i launched Log and Capture. And then everything would start freaking out… unless I had the proper setting…
the rats are getting fat while good men die…