[Luis Sepulveda]

I don’t know how you resolved your problem but this happend to me today. I looked for an autosaved version, rerendered and it worked. Thanks!

SnowLeopard 10.6.3
2x3GHzQuad-Core Intel Xeon
8GB Memory
Two 24″ Cinema Displays
Two 1TB/One 500GB GRaid
FCP 6.0.6
AJ-SD93
AJAKonaLH
Peavey PV6

[Luis Sepulveda]

YES! This helped me! Thanks a lot!

SnowLeopard 10.6.3
2x3GHzQuad-Core Intel Xeon
8GB Memory
Two 24″ Cinema Displays
Two 1TB/One 500GB GRaid
FCP 6.0.6
AJ-SD93
AJAKonaLH
Peavey PV6

[Luis Sepulveda]

Sorry for not posting earlier.

Thanks for your reply.

It’s been a while now, and an employee from the university found the breakout cable stashed up in room somewhere. Also, I ordered a Flander Scientific monitor and the AJ-YA93P panel for the AJ-SD93 and connected all of them.

It’s only now that I notice that I should have also ordered the SDI panel for the AJ-SD93. But for now I have to work with component.

The monitor is connected to the SDI output of the Aja LHe, aside from that everything else is analog.

I disconnected the Breakout box and went directly to the VTR to input and output video.

My audio setup is a bit confusing. I have a small mixer that has input from both the built-in line output of the MacPro and from the SDI output of the monitor.

My audio playback from FCP sounds better from the built-in output than from the loop through the monitor that is activated when the Aja has audio playback activated inside the A/V Settings in FCP.

For now I’m paying attention to the better audio.

Should I do this or am I missing something?

SnowLeopard 10.6.3
2x3GHzQuad-Core Intel Xeon
8GB Memory
Two 24″ Cinema Displays
Two 1TB/One 500GB GRaid
FCP 6.0.6
AJ-SD93
AJAKonaLH
Peavey PV6

[Luis Sepulveda]

I also needed this. Very Helpful indeed. Thanks.

SnowLeopard 10.6.3
2x3GHzQuad-Core Intel Xeon
8GB Memory
Two 24″ Cinema Displays
Two 1TB/One 500GB GRaid
FCP 6.0.6
AJ-SD93
AJAKonaLH
Peavey PV6