[Karlis Kay]

Another way is to select the clip you want to swap, hold down the option key and drag the selected clip over to any edit point you want to insert the clip into. You should see a little curved down arrow. Once the clip looks like it’s going to snap into position, release the clip – it should lock in leaving all other clips in sequence.

Actually – that’s a pretty poor explanation. This video does a much better job…

https://vimeo.com/7853624

Hope that helps

Some contents or functionalities here are not available due to your cookie preferences!

This happens because the functionality/content marked as “Vimeo framework” uses cookies that you choosed to keep disabled. In order to view this content or use this functionality, please enable cookies: click here to open your cookie preferences.

[Karlis Kay]

Hi there – I have the exact same problem after sending to color. I get an x and I can’t add transitions. I rendered out my clip and cut it again so I could add cross dissolves between the edits, however, i can apply every transition except the cross disolve.

It was working before i sent the sequence to color.. so why not now, especially since i’ve rendered out and re-imported the whole file?
Any help would be greatly appreciate 🙂

Thanks

[Karlis Kay]

Here is another video – this is ripped straight from the flash card.
https://www.youtube.com/watch?v=MoH4XeMbqlY

again – any help would be most appreciated
dn