Replies – Forums – Danny Thompson – Page 3

Forum Replies Created

Page 3 of 3

← 1 2 3

Danny Thompson
August 16, 2013 at 2:35 am in reply to: DaVinci deck output -> AJA KiPro

But isn’t it supposed to support decks in general?

Oh well. Back to the FCP broadcast safe filter.
Danny Thompson
August 15, 2013 at 2:43 pm in reply to: View node output, not output image

Not what I’m looking for.

Seeing the grade up to a node is more useful because it lets me decide what I want to patch into the layer mixer.
Danny Thompson
June 20, 2013 at 11:48 pm in reply to: 59.94i project – relinking MXF imported 23.98 media

I feel my biggest stumbling block here is that the master clips have different start TC than the camera media. The project was consolidated so the media has been trimmed. Do I have any hope of relinking to an AMA of the camera media here?

I also have an older bin file that contains original imports, albeit offline. I could theoretically relink these to an AMA of camera media, correct? Would that be of any use?
Danny Thompson
June 20, 2013 at 8:05 pm in reply to: 59.94i project – relinking MXF imported 23.98 media

“Source file” metadata is present for all of the media, yes.
Danny Thompson
June 18, 2013 at 9:26 pm in reply to: 59.94i project – relinking MXF imported 23.98 media

My Avid is v6.0.1 BTW.
Danny Thompson
June 18, 2013 at 9:24 pm in reply to: 59.94i project – relinking MXF imported 23.98 media

If I open the bin in a 23.976 project, give it a tape number, then switch back to the 59.94i project that relies on that bin, will that disconnect it from its clip in the timeline?

In that case, would relinking the media in the timeline to my upres material still be impossible?
Danny Thompson
May 24, 2013 at 2:50 pm in reply to: Manually Entering Timecode

Yeah, and they still are if you want to do anything other than move your mouse around the screen all day
Danny Thompson
May 23, 2013 at 6:22 pm in reply to: Manually Entering Timecode

This software has been gimped so heavily to sell Resolve panels it’s ridiculous.
Danny Thompson
May 23, 2013 at 6:20 pm in reply to: How did I not know about this! My Tangent Wave just became 50% better!

Controllermate does not remap controller functions, it just performs additional actions when buttons are triggered. Some controllers have native drivers for Controllermate but the Wave panel is not one of them, unfortunately.

Page 3 of 3

← 1 2 3