Dan Marlow
Forum Replies Created
-
Hi. You could try re-installing the software and seeing if this sorts out the firmware.
-
Should run fine. You may be limited in terms of external peripherals as a mojo will conflict with any other fw device like storage. However, that said the i dont know if this limitation applies to using the fw 400 and 800 ports. But software-wise you should be fine, as i have run MC soft on my imac at home which is lower spec (1st generation intel 17″).
-
Is updating the software to 6.02 or.03 viable for you? I think 6.01 was a little buggy.
-
Hi. How is the internal hard drive looking? If it is near full, that would be the cause of serious slowdown. Try to keep at least a third of your internal hard drive empty. The other thing to try would be reapiring your permissions using the Disk Utility.
-
Are you sending from FCP to Compressor? If so, try exporting a QT ref, and then opening compressor as a stand alone appliccation. The “Send To” is no good really. Either takes forever or crashes. Also try targetting a different drive, maybe the desktop and also reset background encoding in compressor.