Replies – Forums – Chang hun Kim

Forum Replies Created

Chang hun Kim
March 1, 2011 at 10:02 pm in reply to: I have a problem with converting mjpeg avi and audio

Thank you Cory,
You’re my Savior!
I’ve just sent encoded mjpeg avi with pcm audio file to my client.
I’m just waiting if my client would complain about it or not.
Thanks for the knowledge about difference between two!!
Chang hun Kim
November 16, 2010 at 8:29 pm in reply to: Lines keep going up on the DV footage.

hi John,
Thank you so much for your quick reply.
Yes you’re right. Lines moving from the bottom to the top and we recorded it separately.
it was connected by BNC cable from the camera to the DV deck and it finally went to the mixer, but it recorded on the DV deck because camera itself has a recorder problem.
we used three cameras and recorded it on the same condition; each camera was connected to each DV deck on the purpose to use the 184 minute DVCAM tape.
But the only one recorded footage has a problem so I thought it was BNC cable problem, which was connected from camera to DV deck.
You really think there is noting I can do to make it better?
I don’t know what to do. I think I’m in the real situation.
My client will definitely be made at me.
I really appreciate your reply again.
Chang hun Kim
November 16, 2010 at 6:48 pm in reply to: Lines keep going up on the DV footage.

for more information,

I’m working with FCP version 7.0.3, DV NTSC Project and will finally meke it to NTSC DVD.
Chang hun Kim
July 13, 2009 at 9:26 pm in reply to: It is really slow when I adjust berzier handle on the viewer.

I do turn on “Hardware Accelerate Composition, Layer and Footage panels”. But it is still same. Only it is working smoothly when I set “no motion path” on display tap.
Chang hun Kim
July 13, 2009 at 7:26 pm in reply to: It is really slow when I adjust berzier handle on the viewer.

I just got a crash information about displaying motion path.
When I turned off motion path display, it was working well, but I can’t do key frame animation without seeing a motion path.
some one has an idea about it?
any help would be appreciated.
Chang hun Kim
July 13, 2009 at 7:04 pm in reply to: It is really slow when I adjust berzier handle on the viewer.

I tried to downgrade driver version but I can’t.
After I installed older version of graphic driver, I see it is installed on Device Manager with a notice icon. But it says no driver is installed on display settings menu. So I tried to install manually, but it says “newest version of driver is already installed.”
I don’t know how to figure out this problem. I just came back to newest version of graphic driver. And still has a problem with AE CS4.
I bought Firepro V5700 because many benchmarks say that Firepro series are much better than Quadro series for Maya.